ISX single cam gear adjustment 

These are great videos. You should make more!

Súper clean work area, nice video

One of the most helpful video on YT. Thank you. I’m gonna be doing my camshaft myself for the first time on an X15 and this video helps a lot.

Very good explanation

Awesome video

Great. Thank you!

exelente video gracias saludos desde colombia❤

Love it.

thank you sir

Nice video bro especially the camera is very close thank you

Nice vid man I'm doing 1 right now at work and everybody at the shop has different ways of doing. But your way seems a lot simpler. I'm working with a isx w/o scissor gear will the adjustment process be the same?

I have a comment/question. My 2016 isx 15 in apart now. The shop found the scissor gear and bushing apparently wore causing grooving of the front cover about 1/8". I'm quite sure this may have been a cause for rattling noise. My question is however is there any TSB covering this part as the motor has never been opened and has just under 700k at 596986 miles. Of course this gear and related components will now be replaced but I'm finding it difficult to get more info on this.

Can you please post the tool part number for the injector cup pulled and installer!

Nombre quiero ver un poco de todo lo que ustedes hacen🔧👍🏼

I work for a fleet and I have an upcoming job. I gotta replace the front cover gasket. I need to pull the timing gears. I've never don't the job but I have all the info I need and I am comfortable doing it. Im just not familiar with setting the crank shaft pin and cam wedges to lock the timing in. A video would help but any advice would be much appreciated

Question what is the torque on tha little idler gear that move the high pressure fuel pump ?

Hi can you helpme i remove the tone ring for the cam and now i dont know how instal for get the rigth position

Tku bro . How about on the cm871 “Cummins?

What was the fuller gauge used?

In your estimation which is better the single cam or dual cam!

Do u have to readjust the lash if u have compresor out? My parts guy was being lazy and didnt order the gasket so I went ahead and did the cam gear lash with all the other gears besides the fuel pump until the gasket comes in, it just came to mind that it might shift teeth when i put it back in

Excelente trabajo 👏 hacen videos en español

Hagan un tutorial de un isx15 head repair

thank very much...from toronto canada si lo puedes haser en espanol please

This video was very helpful I have rebuilt four of these motors in our fleet and I did it just like you have shown but I still get a lot of what sounds like gear train clatter the motors have been running fine for about a year just thought you may have a idea as to why it's so much noise.

Looks kinda hard but really its easy after the first few times

Why are there manuals that say the calibration gauge is 10,000? And does not speak of 4000? Thanks

Aren't the shims supposed to be ten thousandths?

isx Cummins front engine crankshaft seal

👍 ur location

Your not supposed to disassemble the cam gear. It says it right on the gear in the video….

It'[s not 109 ft/lbs. Its 75lbs then 120 degrees. you messed up big boi.

If the ISC does not have a scissor gear and there is movement in between the fuel pump gear and camshaft gear, is that normal or need to be tight?