Jeep turn signal or Multifunction switch replacement TJ or Cherokee Don't pull the Steering Wheel 

Precise, easy to follow, no steps annoyingly skipped, a perfect template for fixit videos. Thanks, exactly what I needed!!

This is the best video I found! I had it torn apart when I watched it. You dumb it down enough for someone like me, but not so much, I say "no💩" the whole video. Thank you sir! I didn't know about the relay and wiper switch! You made it a 10 minute install for me!

Great video! Only other thing I did was test it before I put covers back on steering column. Found out my new relay wasn’t good and I needed to replace fuse under the hood. Then all worked.

This video was just what I needed. Thanks so much for putting it together.

Exactly what I was looking for, thanks!

Thanks for the video. Worked for me.

Thanks, once my part comes in, I will follow your easy steps. Thanks again!

Thank you very much for this video made it easy for me to change on❤01 tj Wrangler Sahara

Awesome thanks a lot got this job done in 20 min thanks to the video

Worked great! Thanks!

That's right Jeep designers, always mix the philips head and torq on the same section so that you piss everyone off.

🙏Thank you.

Thanks for the video sir..question..what would you to keep moisture outside of multifunction switch..becauss every summer I have to purchase a new one 😮‍💨

Do you know what the function of the white plastic tab that is spring loaded on the bottom left of this part. Looks like it fits over the column or up against it. I replaced mine, but the turn signals, nor the hazard lights work. Has a new flasher relay, so its not that.

What's the torque size?