Kiddie Pool Cleaning with Filter System, PVC structure, Siphoning/Priming, Shark Bugs, etc. 

*Loooove that tip!!! 😇😇😇* Sharon in SC

I don’t remember! I now use this as an antenna I will see if I can measure it. Note that I used the wrong kind of pvc I think I mentioned that in the video. We upgraded to a non inflatable pool and it was well worth it. Same footprint.

@@sunnywiz thank you

I could not take a picture but basically I had cpvc which is smaller and then I wrapped electrical tape around it a LOT to make a bump that I could clamp the hose onto. The original video I watched the dude said that normal PVC = “tight fit” but doable. Cpvc is smaller than pvc and I think the measurements are inside not outside diameters

My video, the description, has link to original video that I followed

@@sunnywiz thanks

I had the same thing happen to me Haidi and Al Wang! I wasn't able to understand why it was doing it either, but you're not alone!

It’s on a slight slope so I tend to keep the water an inch below the fill line. Water is super heavy!

Update: I think over time the weight of the water stretches the plastic and it bows

You need to reinflate the bottom ring if the pool is sagging.