KSGER STM32 Soldering Stations comparison SW 2.09 vs SW 2.10 version 

Thanks for taking the time to do this.

For a more accurate reading of the tip temperature with the thermometer, tin the tip and put a small dab of solder on it to assist with heat transfer to the thermocouple. Downside is the thermocouples won't last as long, but OTOH you'll have much more accurate readings. I know you were measuring the time for the tip to heat up, but pre tinning it beforehand would still help in that aspect. You just wouldn't have an already molten dab of solder on the tip.

Awesome vid 😎 thanks for taking the time to compare the two versions. I am about to buy one and was wondering what the difference between the two versions was.

Nice video, I have been studying about getting this unit. I ordered me one today from Banggood. Im a little concerned as I have seen comments in other videos that unit arrived dead. As with buying products from China there is a little luck of the draw.

Have just got the 2.10 version of this iron from ksger's aliexpress shop. I've managed to figure out all the other menu stuff, but setting the tip type is proving difficult. I can tick and un-tick the tip types in the main menu option, but how do I actually select which one I'm using to get the correct PID profile?

Thanks for your good work. I followed both of your links to Aliexpress and both went to versions where the aviation plug is soldered to a board rather than to wires with a plug on other end. This will not suit my unique application, unfortunately. Any tips on where I can locate one exactly the same as Ver 2.10/2.1s would be appreciated. ( in relation to the aviation plug being soldered to wires rather than a board. ) Cheers.

The version 3.1S in now out and I'm wondering if buying a new version instead of the (cheaper) old ones worth the extra money. Is there any change in performance? safety? Also note that the most safety problems are about the power supply which seems the same between the different versions.

Nice video thanks. I received my KSGER T12 station and like yours it comes up with ‘Error’ on the display. However my tips have not arrived yet but the iron and cable are plugged in. Is the error caused because I don’t have the soldering tip inserted? Thanks for your help.

شكرا thank you

Where you get that ruler?

How do you find out which version you have ? I have ordered my station , and would like to be able to find out which version it is when it arrives . Thanx for the video .

340 vs 380 degree?? something is going wrong with the settings i think!

Your 2.10/2.1s has the old (2018 model) "daughter board", the new model for 2.10/2.1s (2019 model) looks like the one on your 2.09. You can check it on the official store of KSGER. Also the new handle is better, those 2 are the old ones.

Lo sentivo dall accento che sei italiano e ne ho avuto conferma con "avvio" nel timer, se hai provato qualche hakko o weller come li compareresti con il ksger?

Sei italiano ? bravo comunque 👏

in your opinion what is better?

Where did you get that ruler?

Been sent 2 now neither have worked

De ja vue

The Bo - Please measure the rods used within (in mm). I paid for one of these 2 months ago (still waiting for it but it's supposedly only 23 days away) and have seen many offers/discounts/coupons for the rod/tip device used by these... But I was never able to order any of them because KSGER doesn't tell you what the included T12 units sizes are. It is arriving with a chisel tip, but I most often solder SMD devices like resistors so I need an extremely fine tip! I haven't been able to take advantage of any discounts of advantage because I cannot get an answer for the size of the rod/tips used by this. So long as the units I buy are standard 10k ohm units I have little to fear as changing a few wires is no problem at all.