things i noticed. most importantly is when someone says they run 2 degrees of camber they are talking 2 ON EACH SIDE. with this you would have to set it to 4 degrees, adjusting each side the same amount (2 on each side). this system makes it harder to tell if both sides are have the same toe or camber. you dont need to keep switching the lazer from side to side. just adjust the other side, the board will move. the lines on the turnbuckles indicate which side is right hand threaded which makes it easy to tell which way you should turn them to lengthen or shorten them, orient them all the same (all to the left or right).