Hello. I need some help from you! I have the exact same card! The card has a design flaw in my opinion. Across L and R input there is 20k resistance and there are no input capacitors! The signal should have been mono wired at the output of the op amp ic. and not on input! 20k resistor over L and R can lead to nearer mono sound! If you take output from a preamplifier and run it into both an amplifier and a bass amplifier then 20k resistance over L and R is not good. There is also no capacitor on the input! What is your professional opinion on this! Be a little technical!
is their a good place online to buy those AC transformers? Ive tried googling them but not a large selection from any site I'd trust. I have a few, but most are way over 24v/24v , mostly salvaged from older electronics. also thanks for the close up of the board. those look like nice higher end components.
Why is mine so quiet, I have my amp wierd to the pcb and the sub wiers to the output on the pcb, does the output of the pcb need to hooked into another amp?
@@12voltvids thanks for the answer. My main amplifier has two channels , no subwoofer exit. Do i need a pre amp for the input of my dedicated subwoofer? T am thinking of those tube buffers you made in other videos . Would something like that suits ??
I saw the same butt hurt moron JOhn Senchak on BigClives comment section complaining about Clive sending him an invite to the Isle of Man for a meet up. What an idiot.