make your Penny Board faster 

damn homie that’s a whole lot of science

he was joking

​@@vdfritzzI guess I read the setup, but what was the punchline?

@@vdfritzz no he is not

damn i wish i was in Mexico rn

my g ❤️ thank you for subscribing and turning the bell on. fingers crossed for you homie, see you at 2k 🙏🏻

stay tuned for the giveaway!

thank you homie that’s a nice ass thing to say 🙏🏻 i’m fired up you’re enjoying the videos :)

speed matters less. Think about how much less you have to push with better bearings.

thank you Jeremy! Malaysia sounds dope, i’d love to visit one day 🤞🏼

damn homie that’s lame... im giving away a brand new Penny Board at 2,000 subscribers and I promise it comes with all the factory washers and spacers 🙈

look for a tutorial on cleaning and lubricating the bearings easiest way: buy kerosene and machine oil/skateboard bearing lubricant, put a bit of kerosene in a glass container, enough for all the bearings to be submerged (even though the others seem fine) and leave it overnight next day you pull them out from the kerosene, use some paper towel to dry the excess fluid, then spin them with your fingers as fast as you can for a few seconds each, this will get rid of most of the fluid, then apply the lubricant of your choice (i use standard machine oil) and install them back seems complicated but it's still easyer than removing the little plastic inside the bearing that holds the little balls, if you're willing to do that (your bearing can't be metal sealed from both sides though, most skateboard bearings aren't but some shops sell generic metal bearings on their skateboards), then you can use dish soap and water, there are some videos teaching how to remove this little plastic thing i'm talking about

Bones Reds for sure and I also like my trucks a little tighter than they come stock. other than that tho everything else stock is the way to go!

my g

more Penny Board videos on the way!!

i just restored some 10yo reds my brother replaced a while ago, some of them were very sticky i removed that white plastic on the inside, cleaned everything, lubed it and it's still going fine, a bit noisy of course but still rolls freely for a long time, i installed them on my penny, on my standard skateboard i'm trying independent bearings and they are allright too

thank you! 🙏🏻

if your pennyboard has better bearings then maybe it's not fake

@@blockmanufacturer714 idk the whole board seems fake and not manufactured by penny so idk but i changed my pennyboard bearings with fidget spinner bearings now they spin for half a minute and i actually catch speed now :D

@@insidius999 my wheels in penny is kinda different so idk if it's my bearings or the wheels, I have jelly wheels

thank you homie 🙏🏻

my g ❤️

😩😩

It broke really

@@natsugaming1984 yeah a Ford F-250 ran right over the front and demolished the trucks and upper part of the deck :/

@@speedycs2085oh a frickin truck

thanks for subscribing! good luck :)

Lew is my dad

@@dayswithjase nah

thank you for subscribing! good luck homie 🤞🏼

oooo I’ve never tried Bronsons! I’ll have to get a pack