Making An Oil Catch Can 

+Ken Harvest that's a good point

+Ken Harvest that's a good point

Thank you

Corey portelli My guess, is the filter breather is a bypass if things get clogged. The inlet on top is from pcv, getting vacuumed from the outlet by the intake.

@@jonny5ive167 if the top bung connects to the intake the vacuum pressure will suck oil back into the intake due to the long tube the bung is welded to, which defeats the purpose of the catch can?

+Garry Fuller Sr thank you.

Jegs

1/4" Aluminum Weld On Hose Barb !Made in USA! www.amazon.com/dp/B01MQ30RA7/ref=cm_sw_r_cp_apa_i_E7GfBbSWTRXTH

+Bob Is The Builder no the guy that wanted this just wanted a drain plug on the bottom. Thank you for the compliment though

I thought the point was to keep oil from returning. Or is it to keep oil from getting into the intake and causing buildup

I literally can't tell you how helpful your comment is

@@PeterPetrakis Lol, I guess I could have been a little more specific, eh?

What problems do u see?

@@chriskubond6314 1) he used steel wool instead of the steel coils (pot scrubber) for the filter media. On top of that, he used way too much. The steel wool will break apart and can get sucked back in thru the engine... but his won't because of the vacuum leak. 2) if you're going to run a vent filter on a closed loop pcv system (relying on engine vacuum) the vent filter needs a check valve so the vacuum side isn't just pulling air thru that filter. That filter should only allow air to escape in the times when the crankcase pressure exceeds what the engine vacuum can evacuate. To my knowledge the mighty mouse catch can is the only one employing a check valve in the air filter. I'm not endorsing them, I'm just saying they're the only can I've seen do it right. 3) I would have cut the intake pipe off just after it passes thru the baffle. If you take it to the bottom (as shown in this one) you can have a backflow of oil because the tube coming in will be submerged in the can, and it's not getting any help from the vacuum side because of that air filter. The materials and workmanship look great. He did build a nice looking can. I just know the design of it could be better.

@@brussell639 good info. I'm trying to build my own catch can and need as much imput as possible. Thanks brotha

+Jordan Bronson but then u can't say you made it lol

+Danmo's World - LMFAO !!! I spend time making Money, then I buy... Take me less than 10 minutes to make $15 Bucks... Take me Hours to make a Can, ok.............. LMFAO !!!!

@@JodBronson you clearly miss the point on makin something for your ride vs. buyin somethin already made. You point it on on your ride that "I made that".

@@Ryan_1997 - Sure, if you are making a Space Shuttle! For a $15.00 Catch Can? I'd be embarrassed to point that out to anyone! Maybe grow some 'Self Esteem', because it's NOT a 3rd Grader of Show-and-Tell! 😂😂😂😂😂😂😂😂😂😂😂😂😂

There is only one job I know of that you make $15 in ten minutes.🤤🤤🍆 Not the route I would take but live your life brother!!!!!!