Meepo V3 broken washer wheel grinding fix

Подписаться 252

Просмотров 1,5 тыс.

50% 1

so my left hand motor wheel on my V3 was making a horrific grinding noise.
It was the classic washer fault, I have ordered and installed a new one.
The new improved washer is ebay item number 293662925811.
If the item vanishes, the washer is
21mm / 15mm / 1mm
Available from the ebay seller screws_city2 (no affiliation)
While doing so i decided to make a photo guide.
If you feel it has been helpful, buy me a pint via PayPal 👌
Dynomite411@hotmail.com
I am more than happy to help with the swap or do it for you if you're local to Bournemouth for beer tokens 👌

Авто/Мото

Опубликовано:

29 дек 2020

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 12

@BallCant Год назад

It was making just noise? My meepo v3 "brakes" slightly by itself when im on uneven terrain and looses power little bit. It could be the same problem? Im looking for the fix..

@TheAETHER22 3 года назад

Helpful vid. Do you know perhaps the exact dimensions of the washer so i can order some high quality ones?

@Epic_RC_Time 3 года назад

Please see the description

@aidancox450 2 года назад

@@Epic_RC_Time where is the description?

@demonetizedhistory5806 2 года назад

At 0:41 how did u pull that protective cover back to expose the washer??? I'm trying but I dont wanna break it. Like someone else asked, did u use a vice and rubber mallet to remove it?

@Epic_RC_Time 2 года назад

Give it a loving tap with a hammer

@wumarty3214 3 года назад

hello how did you put the thing down on the crete they are screwed PU I can't get it down to replace the pad of any advice?

@Epic_RC_Time 3 года назад

Hello Please could you elaborate on the question?

@wumarty3214 3 года назад

@@Epic_RC_Time hi, i have the same problem. how did you get down the part on the video 0:41 i don't know how i don't want to damage that part please help

@wumarty3214 3 года назад

@@Epic_RC_Time did you use a vise and a mallet?

@Epic_RC_Time 3 года назад

@@wumarty3214 undo the 4 bolts on the trucks holding the wheel on. Then tap it with a hammer away from the board and it slides out. The bottom of the motor bell should slide down the cable once you have undone the bolts holding it to the wheel. If it doesnt then tap it with a hammer to loosen it up.