Mitsubishi MR-J3 servo amplifier, wiring, jog/position test with MR Configurator 2. Part 1 English 

these channels crack me up. really great for getting devices up and running but the views are always so low. thanks for the help.

Have you ever use the cn3 connector to use the position mode? Because in a CNC the controller would have only the step/dir signal. So Im wondering how to connect the servos like that. I just purchased 2 of them at 1.5kw.

Hello, I would like your help, I need to do a project. The PLC, an FX3U, will send the MR JE C servo to rotate to one side a certain amount of pulses entered into a register on the Sankoom HMI, when it reaches the count, the servo returns to the value of 0. Could you help me with the pins of the CN3 connector and the configuration parameters in mr2?

How about STEP/DIR control - is it possible with these amplifiers?

I like to learn about servo drivers repair

How can you program it via the TIA Portal, PROFINET?

US three phase is usually 208V @6:32

Hi, can you tell me what are the differences between the two cables for the servo motor: MR-BKS1CBL5M-A1-H MR-BKS1CBL5M-A2-H What do the symbols A1 or A2 mean?

Sir tell me DBR connection in Mitsubishi drive MR-j4-11KB

Can I use MR Configurator 2 software to connect to a J3 drive?

Hi, how can ı run pul,dir ı have a motions card ı dont know whic pin ı will connect it

Dear sir, Mr-J3-40B display 24, how to fix. Thanks a lot!!!

3:47 How can I search for that device that distributes power?

Ok mane