If I left my mytee turbo on but no water flowing through will it burn out? Or does it have an overheat protection? The merchant simply said turn the pump on before the heater, then turn the heater off before the pump when finished.
Thank you bro. I haven't has a clog yet that because I do deescaling with an acidic solution to remove hard water scale. If you do that at least every six months you should be good.
Rig the pump to cycle some fresh water for the first few cycles until water comes clean, then I add ab half gallon muriatic acid to some water and let it cycle, then water until super clean. Should be mint
Hi. Thanks for the video. About the best real world one this is very interesting they are advertised to heat the water to just under 98 degrees ( witch is probably 200f or so ). 150 isn’t really that hot that’s the temperature of the hot water tap basically so it’s a bit disappointing to see this Can anyone confirm they do run at 210f normally?? Thanks
I'll tell you what with the price of fuel electric units are getting very popular again I use an immersion tank with a 180 heater in it and then run that into a mighty hot turbo get impressive heat
If you use warm water inside the water thank it works, but if you use cold water it doesn't work, I use 2 hot turbos to work, it's the only way to work with cold water.
Yes your right you definitely need to put hot water for 1 heater you usually have hot water available. I crank up the house water heater all the way up to very hot that also helps.
@@tonyvargas6981 When i used to use them , i used to daisy chain 2 of them 4800 watts heaters together i used to have really hot water. The down side was i had to use 2 generators for my van setup 1 for the heaters and 1 for my extractor. But it was hot then i decided to go with a diesel heater from magic wand company because i didn't want to use 2 generators but i think now i had better heat with the 2 hot turbos then the diesel heater that i have now.
@@larryisaac8988 That's not going to work. The mytee escape is 7000 watts by itself, plus 4800 watts Turbo that's 11800 watts total. A 12000 watts generator only has a 9000 running watts. It's not going to work.
