Neck Pickup Routing with Set Neck

Подписаться 39

50% 1

This video shows me routing the neck pickup in my set neck guitar. Now that I have gone through this process, I'm pretty happy and confident, but getting to this point required a bit more work than I anticipated. But not rushing things, and thinking things through paid off big time.
01:19 Initial Setup with Template 1
03:14 Hogging out excess material
05:42 Securing guitar to workbench
06:14 Routing begins...or does it?
07:37 Router bit change 1
08:18 Problem 1....
09:04 AN EPIPHANY and REGROUPING
10:45 NOW we're GOLDEN!!!! (with Description)
12:25 Routing begins
15:23 didn't blow it!
15:33 RESULTS
#dewalttools #kansascitymusic #samsaraguitars #guitarmaking
#luthierlife #luthier #woodworking #audiocaverecording #routing

Хобби

Опубликовано:

21 янв 2023

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 4

@petecoates6410 Год назад

Nice one ! Yours is the only video I have found showing how to make a template with a neck cutout to use with a set neck. The only other method i have seen is on the LP luthiers forum where many builders make a box jig to sit the guitar in after the neck has been glued and then rout using a template on the box “lid”.

@scottmartinezguitarandbass Год назад

You're telling me! I'm pretty new to all of this so I kind of had to puzzle things together and figure it out for myself. Hope it helps!! :)

@petecoates6410 Год назад

@@scottmartinezguitarandbass cheers Scott. I like that clamp assembly on your drill press. Is that something you rigged up or is it a fitting you can buy. I have a great Fobco pillar drill but could do with a hold down solution like yours. Nice guitar too btw !!

@samsaraguitars Год назад

@@petecoates6410 It's an aftermarket clamp, it's way too hard to hold a workpiece super still and be accurate - and my particular drill press jolts when I turn it on, and I would lose my mark after I carefully lined it up. HAHA. This clamp made it SUPER easy and comes in handy. I had to drill a hole in the steel of the table, but it was actually very simple. I love it! I just got this one on Amazon: www.amazon.com/dp/B07CJ3XZPL?ref=nb_sb_ss_w_as-reorder-t1_k0_1_15&amp=&crid=3F4FYQEE6JYHD&amp=&sprefix=milescraft+4007