Nissan Navara with hard to start symptoms. once the engine starts it will either idle while engine is shaking or completely stall out. revs would not accelerate
On these Nissans, you have to do a fuel pump reset when you replace any component. Method is: Ignition on wait 3 seconds Pump accelerator peddle 5 times in 5 seconds. Wait 7 seconds Press and hold accelerator peddle for 10 seconds, engine management light will start blinking, Wait for 1 minute then turn on the engine and let idle. It will learn the new parts and also rev normally and start to relearn fuel consumption etc and drive better with better economy also after this. Then peddle
had similar issue with 2010 Nav that shock volitant on startup in cold weather after a Timing chain upgrade to Duplex chains, it eventually wound not turn over at all, so It went back to the Mech's Shop that replaced the chain and they replaced the Starter Motor and said the that Knocking was most likably a faulty injector, $2000+ send away and have them cleaned etc, I watched this Vid and thought that's got to be a cheaper alternative by far and it was so far. Need a good Scan Tool any suggestion's?
My d40 check light keeps coming on every time I increase the power the van check light comes on and the van goes into limp mode and I get no power at all. Can anyone help ? It works good for a bit than the light keeps coming on and the van loses all power....
Hi, My dad Nissan has P1275 code (saying high pressure fuel pump) . sent for repair, the shop changed the fuel pump & charged my dad for that. but still same. so, my dad was trying to fix himself now. and he was asking "can he just follow the step in this video, though no P1622 code ?" ps, car dummy asked on behalf of cheated dad