Nissan Qashqai Front & Rear Brake Pad Replacement 

Thanks so much for your input and time.

Thanks bro for your tutorials lessons

Great tips, thank you

Hi I am a beginner. reli wanted to try it. Please may I ask which jack point you used to jack up the car? coz after lifting up, I think you put the jack stand under the jack point behind the front wheels. Thanks a lot . thanks for the great video

you can buy the 3 pin part on Ebay just by it self , my brake kit never had the 3 pin also, you dont need a computer , but on one of the brake pads, inner one there is a pin you must line up with slot on caliper wind back or it will not sit right i have x trail same ,i always use copper past but red rubber grease on the caliper pins, clean and check the rubber boots good video's keep them coming

برافو و شكرا great and thank v m

6:49 “why do you make me take part in things like this” 😂 joking I love doing it really 😘

Hi I'm getting a clacking noise in the front driver side any ideas what it could be

Where did you get your overalls from? Been looking for ages for a decent pair

Thanks for the tip on the handbrake but I must admit thought you only grease the tips of the brake pads not the back etc ?

you don't need to rotate back the rear piston, you just need to push them back. infact rotating them back is ill advised as the 3 slots in the piston have to engage in the pins on the back of the pad and if you rotate the piston it makes it more difficult to index the slot and pin correctly.

I am trying to do mine but do you need to take electric handbrake motor off to wind caliper back,my caliper don't seem to be winding far enough back . It keeps turning but don't seem to be going any further back. Thanks

The other way is to remove the electric brake and wind it back with a allen key, you can then use a push back tool rather than a wind back tool.

I've got a Kadjar which is exactly the same. I've been told you need a computer to do rear brakes properly

Just done a brake pad and disc swap on my mother-in-law’s Qashqai J11, exactly the same as how you did yours except I chose Brembo Pads and Discs. Personal preference that’s all. Functionally the brakes work great and the Brembos are very good. We have an annoying high-pitch squeal when braking very lightly at low speed. I thought it maybe because like you I didn’t transfer over the original anti-squeal skims, forgot to unclip them from the old pads and transfer them to the new ones, as the new ones like yours seemed to have their own one-piece shim. Was curious if you have had any squealing too or is it just the brakes bedding in? Car has done around 2000 miles since so I would assume it’s bedded in by now…

Did ya after take motors of rear brakes!!!

Hand brake didn’t need to come off qashqai’s have disc and drum rear brakes handbrake is operated by brake shoes inside the drum on the rear disc and your outer brake pads are for stopping inner shoes handbrake 👍

Copper grease voids warranty on modern brakes . Wurth synthetic paste is best to use now. The caliper pins benefit from old grease to he removed and cleaned. Then red rubber grease

Holaaaa puedes subtitular en Español ?