Тёмный

Oil injection delete on a Yamaha Waverunner 

Coco’s Playground
Подписаться 1,6 тыс.
Просмотров 18 тыс.
50% 1

Опубликовано:

 

29 окт 2024

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 39   
@RealSuburbanCowboy
@RealSuburbanCowboy 10 месяцев назад
I was looking for this exact information. Great video, but when you edit and add music, you need to change the music volume level.
@CocosPlayound
@CocosPlayound 10 месяцев назад
Lower or higher? This video is older
@RealSuburbanCowboy
@RealSuburbanCowboy 10 месяцев назад
@@CocosPlayound music volume. :) like I said, great video with the exact info I needed.
@coreyfarmer3983
@coreyfarmer3983 2 месяца назад
I have same but a 2005 and i started getting oil in bilge. If i wanted to replace the oil lines (my suspicion of leak), is that easier than going this premix/injection cutoff route?
@CocosPlayound
@CocosPlayound Месяц назад
Depends on what you want. It’s easier at the gas pump if it’s injected. But safer at times with premix
@shannonwilliams601
@shannonwilliams601 3 года назад
What's funny it probably was not even the oil pump 90% of the time it's a fuel pressure leak on the tank or on the Rubber seal on the gas cap or on the pop valve it's usually a pressure leak that makes these things run lean it's very rare the oil pump is self now it may be a oil line that breaks but like I said hardly ever the oil pump and nobody knows to check 4 pressure every year before you put your ski in the water
@CocosPlayound
@CocosPlayound 3 года назад
Yea this one had hard brittle oil lines and the guy said he would rather mix the gas
@whatthe2458
@whatthe2458 2 года назад
Do a video showing how to do a fuel pressure test
@josefkeup7468
@josefkeup7468 5 месяцев назад
how do you check?
@juanandino9136
@juanandino9136 4 месяца назад
Hello, nice video, I have a GP 1200r Smokes a lot and also there is a lot of oil on the bottom of the jet. Do you recommend I should do the same?
@CocosPlayound
@CocosPlayound 4 месяца назад
Yours is still oil injected?
@dd1978us20
@dd1978us20 Год назад
How do you stop the oil warning light after installing the block off plate? Is there a specific connector under the steering column in the harness?
@CocosPlayound
@CocosPlayound Год назад
Probably can split the wires together but I usually just leave a little bit of oil in the tank
@anesbounaceur
@anesbounaceur 10 месяцев назад
Hello brother, plz i got a 2005 waverunner 700 xl , i want to go on premix too without by passing the oil pump . So my question is : is it ok to just directly empting the oil tank and go straight forward with the premix without bypassing Thank u so much .
@CocosPlayound
@CocosPlayound 10 месяцев назад
I mean it’s not recommended bc the oil pump will run dry but I think it’s possible
@joshuaramquist9909
@joshuaramquist9909 Год назад
Should the exhaust gasket be replaced after removing, and do the head bolts have to come off the get the chamber out. Don’t want to risk breaking them
@CocosPlayound
@CocosPlayound Год назад
Yes it should be raplaced. I sometimes spray coppertone on them if they are metal. Head bolts don’t need to come off
@joshuaramquist9909
@joshuaramquist9909 Год назад
Yeah I was referring to the smaller two of the four bolts that hold that plate on . I was able to get it the exhaust out by taking it apart in two pieces. Another crusty Yamaha lol
@CocosPlayound
@CocosPlayound Год назад
@@joshuaramquist9909 yes they do
@joecamp141
@joecamp141 Месяц назад
Did you have to bypass sensor and reservoir
@CocosPlayound
@CocosPlayound Месяц назад
On the level sensor you can connect them together
@JustinTwilley
@JustinTwilley 3 года назад
Hey I have an 07 1300r is there anyway to see the oil lines to see if clamps have been upgraded without removing exhaust? If not how long did the exhaust removal take you? Seems like a headache.
@cadesground2514
@cadesground2514 3 года назад
We always delete them but you have to pull the exhaust
@JustinTwilley
@JustinTwilley 3 года назад
@@cadesground2514 I ordered a camera that I can snake down through there to check everything out so I don't gotta pull the exhaust if I don't have to 😂 it looks like a head ache
@nighttrain3926
@nighttrain3926 3 года назад
oil pumps never fail on a 1300 r, if sumthin happens to throttle it goes into fail safe mode full oil, u need to replace ur oil lines every 3 years or go to a silicone style line will last longer and not get brittle , also make em longer so shrinkage dont pull dm off nipple
@JustinTwilley
@JustinTwilley 3 года назад
@@nighttrain3926 Thanks for the tips!
@ehabk5038
@ehabk5038 2 года назад
Question: do you have to actually do the bypass? What if you just Empty the oil tank and add premix gas?
@CocosPlayound
@CocosPlayound 2 года назад
And take the oil pump off
@phimister78
@phimister78 2 года назад
you could but you would need to block off the oil lines . it’s best to remove and put in the block plate for any possible confusion further down the line when a new owner puts straight gas in .
@valterferreira8171
@valterferreira8171 2 года назад
What caused the oil lines to be hard as a rock. ? And previous owner blew pistons 3 times. Another question if he had a lean problem by adding premixed in tge tank will that fix the lean issue also ?
@anesbounaceur
@anesbounaceur 10 месяцев назад
​@@phimister78Hello brother, plz i got a 2005 waverunner 700 xl , i want to go on premix too without by passing the oil pump . So my question is : is it ok to just directly empting the oil tank and go straight forward with the premix without bypassing Thank u so much .
@phimister78
@phimister78 10 месяцев назад
@@anesbounaceur i would block off the oil pipes so no air was sucked in .
@trentstelly7026
@trentstelly7026 Месяц назад
What is the mix ratio you used
@CocosPlayound
@CocosPlayound Месяц назад
40:1
@27leonardo1
@27leonardo1 2 года назад
so now he mixes the gas and oil? the owner? I have the same problem it's why my question...😥
@CocosPlayound
@CocosPlayound 2 года назад
Yup he mixes the gas instead of relying on the oil injection
@BuyBuildThrash
@BuyBuildThrash 3 года назад
Can anyone here tell me where that oil line that comes off the top of the oil goes.? 🤔 About 1" up it has a baby tiny oil line that come off then the hose goes to a one way valve then I don't know where it goes from there
@alexmozingo8972
@alexmozingo8972 2 года назад
What ratio do you all use after deleting the oil pump?
@CocosPlayound
@CocosPlayound 2 года назад
40:1
Далее
skibidi army returns (skibidi toilet 77)
00:49
Просмотров 2,2 млн
ХУДШИЕ ВЫБОРЫ в США
13:20
Просмотров 505 тыс.
Will this crusty old 750SX run again?
27:39
Просмотров 2,8 тыс.
2001 Yamaha XLT 1200
3:23
Просмотров 3,1 тыс.
#1 failure part on yamaha superjet and waverunner pwc
10:12
99 Yamaha GP800 Oil Block Off Plate
6:01
Просмотров 10 тыс.
Can we get this old Jeep back on the road?
30:37
How to rebuild a JetSki engine part 1
13:10
Просмотров 37 тыс.