P20BD REDUCTANT HEATER B Ford 6.7 Superduty

Подписаться 32 тыс.

Просмотров 4,7 тыс.

50% 1

In this video I go over how to check the heater element when a P20BD code is present.
GRAB THE NEW IN THE SHOP T-SHIRT: teespring.com/in-the-shop-t-s...
Instagram @_intheshop_
tiktok: intheshop1
Email: Nathan@intheshopmedia.com
Please consider donating on my Patreon account. All donations go directly towards making more videos for all of you: www.patreon.com/user?u=201152...
Affiliate links are used. Using these links doesn't cost you any more but i do make a small portion from all purchases.
My amazon Store: www.amazon.com/shop/intheshop1
#DEF #HEATER #FORD

Авто/Мото

Опубликовано:

4 авг 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 13

@stevenfuchs2548 2 года назад

Wow, I knew about the in tank heater but not this one, thanks this is great!

@InTheShop 2 года назад

No problem Steve! Thanks for watching.

@ewerton_s Год назад

Do you have OEM a part number?

@InTheShop Год назад

You will have to look it up at the Ford dealer using your VIN. They used a couple different configurations and would hate to give you the wrong one.

@ewerton_s Год назад

@@InTheShop sounds good thank you. I'm having the same problem and do have the same truck so I figure I ask. It's kinda confusing when they have 6 different setups for the same part 🤔

@ronheiden2750 2 года назад

On a different topic. 2011 f250 king ranch 6.7, EGT sensor fault. Don't have access to a lift, will be doing this laying on the garage floor. Any and all suggestions for this repair will be greatly appreciated. Thank you, Ron

@InTheShop 2 года назад

Hey Ron, first off spray it with penetrating oil the day before if possible. Make sure you have a really good wrench cause they round off easy. Once it cracks free spray a little bit more penetrating oil and tighten it a bit. Keep doing that back and fourth coming further and further out. They can be a pain.

@ronheiden2750 2 года назад

@@InTheShop thank you for your advice. I sprayed it twice yesterday and once this morning with pb blaster. Gunna try breaking loose today

@InTheShop 2 года назад

@@ronheiden2750 only crack it free a bit then spray again and tighten

@ronheiden2750 2 года назад

@@InTheShop would you suggest using heat on the part it threads into

@InTheShop 2 года назад

@@ronheiden2750 only a very small amount. I’ve found if you heat it the threads usually gall. I’ve had a few that I’ve had to either tap the hole or cut the bung off and weld a new one in.

@ronheiden2750 2 года назад

Oh...it's sensor #2