Тёмный

Pouring A 40' X 40' Garage with Heated Concrete Floor 

Mike Day Concrete
Подписаться 292 тыс.
Просмотров 12 тыс.
50% 1

#EverythingAboutConcrete #MikeDayConcrete #heatedfloor
We're pouring a heated concrete floor for this new 40' x 40' garage build.
The floor has 2" styrofoam with pex tubing installed and the concrete was 5" thick.
The pex tubing will be connected to a boiler that'll run hot water through the tubes and heat the concrete. We call this a radiant heated concrete floor. This type of heated floor is very common in Maine for both the house and garage floors.
Pouring the concrete over the pex tubes is very much like pouring a normal concrete floor. We are careful not to damage the pex, but it's pretty rugged stuff and you can walk on it without damaging it.
Most of the heating guys who install this around here like it closer to the bottom of the floor so it heats the entire slab and not just the top half.
Watch us pour this floor in about an hours time!
EMAIL ME - mikeday@everything-about-concrete.com
LEARN FROM ME - PRIVATE MEMBERSHIP AREA:
www.theconcreteunderground.co...
GARAGE FLOOR EPOXY FLAKE COATING COURSE:
www.theconcreteunderground.co...
MY STAMPED CONCRETE COURSE:
mike-day.mykajabi.com/offers/...
MY CONCRETE SLAB COURSE:
mike-day.mykajabi.com/pl/79570
FOUNDATION CRACK REPAIR COURSE:
mike-day.mykajabi.com/offers/...
GARAGE EPOXY FLOOR COATING COURSE:
mike-day.mykajabi.com/offers/...
VISIT MY WEBSITE:
www.everything-about-concrete...
USE THE SAME TOOLS I DO:
36" MBW POWER TROWEL:
imp.i284638.net/oeRMmn
ScreeDemon Gas Powered Vibratory Screed:
imp.i284638.net/4ZKEL
Screedemon Battery Powered Vibratory Screed:
imp.i284638.net/LzdBo
14' Screed Board for ScreeDemon:
imp.i284638.net/QOPDZM
MARSHALLTOWN SHOCKWAVE VIBRA-SCREED:
amzn.to/2tZ79ti
TOPCON LASER LEVEL:
amzn.to/2VrJ3zV
DEWALT PENCIL VIBRATOR TOOL:
amzn.to/2Km5Zis
INVERTER GENERATOR LIKE WE USE:
amzn.to/2XfWfwe
BULLFLOAT:
amzn.to/2U1Kx2F
HAND FINISHING KNEE BOARDS:
amzn.to/2TZmTUj
MAG FLOAT & STEEL TROWEL SET:
amzn.to/2IgmDOq
2" MARGIN TROWEL:
amzn.to/2G33KNn
CONCRETE PLACER OR KUMALONG:
amzn.to/2I00gxp
CONCRETE FINISHING BROOM:
amzn.to/2UytU2B
CONCRETE SCREED:
amzn.to/2WZxtwm
CONCRETE EDGER:
amzn.to/2GbGkEp
CONCRETE GROOVER:
amzn.to/2PaL414
BOSCH HAMMER DRILL:
amzn.to/31AHnaN
MY RECOMMENDED TOOLS PAGE:
www.everything-about-concrete...
SUBSCRIBE to my email list and get my FREE video guide on how to get the perfect broom finish on a concrete patio:
forms.aweber.com/form/44/2003...
Follow me on Twitter:
/ creteexpert
Follow me on Instagram:
everything_...
Follow my Facebook Page:
/ everythingaboutconcrete

Хобби

Опубликовано:

 

21 июл 2022

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 46   
@DavidFreelandAZ
@DavidFreelandAZ Год назад
I get a kick out of how you complimented the mixer drivers. Nice video.
@MikeDayConcrete
@MikeDayConcrete Год назад
Thanks 👍
@sethlawrence8958
@sethlawrence8958 Год назад
Makes me want to go concrete my whole yard. I love the videos, I watch them all the time. You make it look easy!
@MikeDayConcrete
@MikeDayConcrete Год назад
Thanks Seth!
@raulzamora8928
@raulzamora8928 Год назад
Hollywood Matt is back with other stars making a cameo!!!😄
@MikeDayConcrete
@MikeDayConcrete Год назад
He's the man!
@johnfahey7215
@johnfahey7215 Год назад
I love watchin the rakers makin the screed guys job a lot easier!👍😀
@MikeDayConcrete
@MikeDayConcrete Год назад
Easy is what I like!
@stevenjacobs3559
@stevenjacobs3559 Год назад
This is my second time watching this video. Your the concrete man!
@MikeDayConcrete
@MikeDayConcrete Год назад
Thanks Steven!
@brycetaylor1747
@brycetaylor1747 Год назад
You and the crew are a well oiled machine to say the least! It's impressive to witness such top notch flatwork! Hats off to each and every one of you, including the best drivers of the day 😉 Thanks for sharing this video along with all your others, personally I really enjoy the instructional ones even though my flatwork days are behind me. It's awesome to see you educating the future through a platform they can relate to. God bless you sir and all you encounter 🙏
@MikeDayConcrete
@MikeDayConcrete Год назад
Thank you Bryce!
@brycetaylor1747
@brycetaylor1747 Год назад
My pleasure Mike! You are very inspiring with your videos and I'm glad I found your channel. It's giving me a lot of ideas and tips for the channel I'm developing with carpentry. Thank you again and Godspeed
@stevenjacobs3559
@stevenjacobs3559 Год назад
You guys make it look easy!
@MikeDayConcrete
@MikeDayConcrete Год назад
Most days it is easy to us, thanks.
@retiredperson4054
@retiredperson4054 Год назад
Mike your videos are the best! You show the real world of placing mud!
@MikeDayConcrete
@MikeDayConcrete Год назад
I try to. thanks!
@retiredperson4054
@retiredperson4054 Год назад
@@MikeDayConcrete As I have shared with you previously on comments and in emails, I am retired from construction and was involved in hundreds of concrete placements -- my respect for your trade and your skills has, and will always be at the top of the list of those tradesmen and women who not only are extremely hard working but who take pride in what they do -- You and your crew exemplifies those traits - and it is demonstrated by these great live videos! God bless your team! "Retired Person" in KY.
@ianagos4276
@ianagos4276 Год назад
Just had a pour yesterday and man I thought I thought I got the best company in town but y’all’s organization and everything gives a much better product. My new floor looks ok but it’s not that flat like what I see in your work
@MikeDayConcrete
@MikeDayConcrete Год назад
Thank you Ian!
@ryanodea5417
@ryanodea5417 Год назад
Hi Mike, another great video. Do you ever do polished concrete?(what we call it in Oz) where the top is ground down then polished up to expose all the nice stone 👍
@gregwilcox1696
@gregwilcox1696 6 месяцев назад
Mike I have watched a lot of your video's, do you have a video that you put a brick ledge on? trying to see how to Fram for a brick ledge. Thanks
@gladegoodrich2297
@gladegoodrich2297 Год назад
How do you saw cut the same day? Always waited a couple of days so that the diamond blade didn't chip the cut.
@sykehype
@sykehype Год назад
Concrete like water lol 😆
@stevenpringle7813
@stevenpringle7813 7 месяцев назад
Why don't you pull the steel mesh up into the center of the slab?
@aarongrabowski3775
@aarongrabowski3775 Год назад
What was Darren pushing into the concrete at about 6:50 mark
@charlesviner1565
@charlesviner1565 Год назад
👍
@crabmansteve6844
@crabmansteve6844 Год назад
Can you do a video sometime about how you come to a certain price for a bid or estimate?
@MikeDayConcrete
@MikeDayConcrete Год назад
I have a couple videos about that, those are mostly reserved for my private area The Concrete Underground.
@johnfahey7215
@johnfahey7215 Год назад
Old retired raker myself
@raphaellandry3111
@raphaellandry3111 Год назад
What is your laser ? Model ?
@MikeDayConcrete
@MikeDayConcrete Год назад
I'm using the Topcon RL-H5B
@klmbuilders5385
@klmbuilders5385 Год назад
What slump was that on delivery?
@MikeDayConcrete
@MikeDayConcrete Год назад
Most of the time they show up about a 2
@bryaningle6034
@bryaningle6034 Год назад
I'm involved in street/highway construction. I haven't worked with a slump like that in about 15 years. That stuff is wet.
@MikeDayConcrete
@MikeDayConcrete Год назад
It's got High range water reducer so we can pour that wet.
@alanhiggins2928
@alanhiggins2928 Год назад
I can’t see how that mesh does any good laying flat on the the styrofoam and don’t say you lift it up, because you don’t when I’m watching! Anyway you do a fantastic job and the fibre mesh will probably be enough??
@FarmerBenny
@FarmerBenny Год назад
Looks like the mesh is sitting over the heating coils, which will be enough to keep it off the ground.
@jimanderson2518
@jimanderson2518 Год назад
@@FarmerBenny nope the pipe is on top of the mesh ......holding the piping ..... What I did to mediate this i laid rebar in a grid then laid the mesh on top of this, then the piping to the mesh .....there is chairs for piping but the cost is ridiculously high
@MikeDayConcrete
@MikeDayConcrete Год назад
We installed the wire when we showed up that morning, right over the heating tubes. You got to look close, but it's on top of the radiant heat tubes.
@alanhiggins2928
@alanhiggins2928 Год назад
@@MikeDayConcrete it sure looks like it’s under the heater coils on the video! But maybe it’s just my eyes
@justinaulgur9812
@justinaulgur9812 Год назад
This an old video? No leaves on the trees and yall in coats
@MikeDayConcrete
@MikeDayConcrete Год назад
It's from early May
@j.g.orosrodriguez3394
@j.g.orosrodriguez3394 Год назад
Sorry mike i got the best skill for concrete job
@MikeDayConcrete
@MikeDayConcrete Год назад
What are you sorry about?
@alansabin7487
@alansabin7487 Год назад
seeing the concrete boom touching the lines makes me cringe
Далее
One Man Concrete Floor Pour - No Problem!
11:14
Просмотров 11 тыс.
Fudbol hozir vs avval😂
01:01
Просмотров 478 тыс.
Qarindoshga uylansang😂😂
01:01
Просмотров 1,2 млн
How To Pour A Concrete Floor With Only 2 People.
22:38
Pump Truck Was Late! Big 40' X 80' Concrete Floor Pour
17:55
Planning Radiant Floor Heat (Design and Cost)
10:30
Просмотров 8 тыс.
5 Biggest Lies About Manufactured (Mobile) Homes
12:49
1 Man Pouring A Concrete Floor Addition (20' X 12')
15:54
Dry Pour Showdown!
11:46
Просмотров 1,1 млн
40x40 pole barn shop in Ohio
5:31
Просмотров 25 тыс.
ХИРУРГИЧЕСКИ пересадили ТАТУ
0:20
ГИБКОСТЬ 80 LVL
0:18
Просмотров 5 млн
might be my last day babysitting…
0:23
Просмотров 9 млн