Update. Been on a few rides everything is still good. Havent had one single power steering issue since. May want to put some blue lock tight on the adjustment nut
I’m running those exact same tires with a 4” satv portals and a satv rack n pinion and mine has a lot of play/slop also…I’m going to see if I can do this to mine. Thanks for this video man
Could you stack a washer or two under the spring to increase the tension on that bushing?? The hole in the washer should allow grease to get through too.
If you bottom out the spring tension, did you check the bearing? I found my bearing was completely gone on one side. Any idea on where to find a replacement bearing ? I can't find any.
I never even seen a bearing in it. I assume maybe there is one for that input shaft the steering wheel hooks onto but I haven’t had to mess with that part . Is that what your talking about ?
There are 3 punch marks on the aluminum nut to lock it in place. Do I need to do anything before I take the nut off? I don’t want it to strip the threads. Thanks for your help.
Mine are fucked up. If u make the rack Greasable I wouldn’t even worry about it . But there’s a little channel on the rack the boot rides in…. It’s a major PITA to get on there
I’m sure u could but probably won’t help much. U would have to pack it very full of grease and then hope the cap pushes it threw when u put it on.probably just make a mess. It’s not hard to drill and tap the cap