Hello there! I'll need to do both front locks soon and this is super useful even though I don't understand a word of what you say, sadly. A question - how do you replace the bolt you drilled off the upper part of the lock?
Hi, that is a pop rivet, so I replaced it with a new one. I don't remember the size, but it is not the thinest one. All you need is the pop rivets and the pop rivet gun. Good luck!
I'm about to fit a replacement door to my laguna due to crash damage. Multiple questions. 1. Will the lock in the new door work with my central locking? 2. If not can it be programed to work with my central locking? If not I'll need stip the old door and then and fit the parts, what a ball ache
Small question: My keyless entry no longer works on the driver's side, I suspect it is the sensor. Does anyone know if the sensor from the Megane 2 also fits? Because it looks exactly the same.
It should work, but you check on the external handle if you still have the reflective steel cap on it. It is located on the inside of the handle facing the door.
@@scaneru No, the steel caps are missing on both sides. But on the passenger side it works without any problems. I've tried using aluminum foil, but unfortunately that didn't work.
@@legioner9 For me it was the sensor. The sensor has a small switch on the back that is covered with rubber. This rubber has crumbled off on mine, so it didn't work anymore. I can send you the type designation for the sensorsFor me it was the sensor. The sensor has a small switch on the back that is covered with rubber. This rubber has crumbled off on mine, so it didn't work anymore. I can send you the OEM from the sensor. However, the removal of the door lock and handle is a bit complicated. You have to push down a small plastic lever through a small hole on the side of the door with a thin screwdriver and pull a mechanism with another bent screwdriver, then you can take out the door lock. It is best to watch a RU-vid video for this. If you want to make it a little easier, there is a special tool for this purpose. I send a link below, how such a special tool looks like. Left sensor: AV50487002 Right sensor: AV50487001 Special tool: BGS 8816 Link for the special tool: www.amazon.de/BGS-8816-T%C3%BCrgriff-Werkzeug-Renault-Megane/dp/B00JSKBJ58
@@legioner9 Link for how to open the mechanism: ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-l2LsjOE8HmA.html The video is for the Megane 2 and not the Megane 3 but it actually works about the same as in the video with the mechanism.
There is a screw on the side of the door, which is covered with a plastic cap. On the driver's side it's exactly next to the label with tire pressure. Hope this helps.
Am incercat sa scot doar sufa si nu am reusit. Pe forum renault romania unii au spus ca au reusit sa scoata sufa fara sa demonteze manerul. Eu zic sa demontezi manerul, e cel mai usor!
Salut. Sincer nu am inteles nimic din toate clipurile astea. Numarul 1 nu l-am gasit deloc. Prea multa filmare , prea putine concluzii. Daca as avea vreo problema cu asta , as lua de la dezmembrari tot ansamblul si as da 150 lei in service sa mi-l monteze. Deocamdata pe mine nu ma deranjeaza decaj jocul mic de la ambele usi fata pe care il au manerele , joc pe care nu am vazut in nici un fel cum l-as putea anula din cliputile tale.
Salut, bineinteles ca este si videoclipul cu numarul 1. Tot ce am filmat este despre schimbarea motorasului de la inchiderea centralizata (de unde si titlu'). Totul a fost facut pentru cei ce ar dori sa o faca singuri si nu stiu exact cum. Nu e treaba cea mai simpla, dar daca iei de la dezmembrari de unde ai siguranta nu o sa ai aceeasi problema dupa o luna, sau un an. Mai ales ca nu e chiar asa de usor de schimbat. Respect.
@@scaneru salut la mine cand deblochez usile portiera pasagerului nu se mai deschide decat prin interior apoi daca nu o blochez se deschide si din exterior pana o blochez din nou ce ar putea fi ? Mentionez ca nu se mai aude decat un bâzâit cand blochez ușile
