Thanks for the video. the question i have is; is novastar lct compatible with any video wall controller/processor or just novastar video wall controller/processor?
hi, thanks for the video tho, I already have the configuration set on my MacBook Air and send to the screen, now how do I send video to show on the screen? thank you
Hi i am trying to set up my screen but when i get to the screen configuration and send to HW i dont get what is on my laptop showing on the screen, is it something to do with area size that i need to adjust? Thanks in advance.
Hello, thanks for the video! I have followed this tutorial, however, I don't get to display my source in all the screen as one only display, I still see it several times. My Video Wall is composed of 6 LED panels, each with a Novastar MRV336 receiving card. When I connect the Taurus TB6 to the first panel, I can display my hdmi source in the videowall, but I see it 6 times, one for each panel. Could you advise me on how to fix this?
Hi, do you know how to setup screen size?? or more specific.. Desktop size.. I have followed the steps, I have a 4 by 3 (96x96) module configuration, but when I connect my computer I can only see like 1/4 of the entire desktop.
That is because each LED and panel accounts for one pixel. So you either need video mapping software, or on some controllers you can “zoom out. “ Please see the video on configuring the TB6 for an example.
HI! Thanks for the very informative video. We didn't go with the TB6 unit. We have a video processor and have the screens connected via ethercon. We have 32 double panels (500mm width x 1000mm height) in a 16 column 3 row configuration (26' wide 9' 10" high screen size) The problem I am having is 2-fold, sometimes when I trace out the screen connection, they don't create 1 complete screen as if some of the screens aren't in the right order but I know they are, and other times it only fills 1/2 of the screen but that means it is 16 full panels and then 1/2 of 16 panels and then nothing on the bottom 16. The 2nd problem is when I click "send to hw" a message pops up that reads "sending card number:1, network port number: 1 exceed the load range! do you want to continue? Ok or Cancel" Please help.
Do i have to configure each card individually for the amount of led panels, before configure for the total of receiver cards¿? , and second, the wiring matrix is shown there, its viewing from front side or back side? 2:10
Each Rx card = 1 panel. You configure them all as a whole unless one specifically needs work. Wiring is shown from front, but it doesn’t matter how you do it as long as you match it right.
hi can you make some video configuring my P3.91 LED 500x1000mm cabinet with 64 x 64 pixel per module. in one cabinet ther are 8 modules. I have a problem creating RCG file