Setting up Hornady pistol dies 

Thank you for the great video, as you mentioned, there are so few videos on how to correctly, and step by step show videos on the subject of reloading, something that is absolutely necessary for someone who owns firearms and actually practices with them.

Thanks for the demonstation, one thing I did which prevented center screw comming loose was adding a lock washer - works like a champ!

Very well explained. Excellent camera and lighting setup to match the visual with the verbal.

Good video. Followed your steps setting my 9mm dies and it worked very well. Now on to powder charges. Thanks!

Very nice job going through step by step. Excellent Jim.

Awesome tutorial. I still come back from time to time to help me adjust the dies. Thanks!

This video was extremely helpful, thank you for taking the time to make it.

Thanks for the video!! just got my LnL AP w/ Hornady dies in 9mm. Can't wait to reload. Cheers!!

Good vid shows just what I needed to see, Thanks.

Thanks, nice light on your press.

Thanks a lot for your time to do this very helpful video !! A1..

thank you for keeping it simple,

Good video 🇺🇸

Thank you great video

Glad you made this, you helped me out s ton

thank you ! Great video

Very helpful. Thanks

Great video. Just got the same press. Going to be loading 40s&w.

Super helpful!

old video, but you need a lock-washer on that centerbolt ;-)

good work sir

Thanks for the video. I have a question about the powder drop. do you need a special die for the 10mm/40cal or is it universal where any case will activate the powder drop? Your video was very helpful.

Very nice video. Do I need a different die for the powder for each caliber?

you should have more subs. I watched 4 other ones couldn't see anything they were telling me to do. Whats that tool you have called. . red wrench zi nerd one. thanks for making this video.

Does the shell plate holder tool come with it?

Does this take out a spent primer or is there a tool to do this?

What size of hex head are you using to tighten the ring screw?

You added the bell to make seating the bullet easier at station 2, at what station was the bell taken out, I am assuming the seating die performs two operations, one is to seat the bullet to the correct depth and the second function is to remove the bell that was put in at station 2, by that I mean to remove it so the wall of the case is straight again.

Use a factory load to adjust depth, no mic needed

Dude...that right hand pinky finger nail tho....scoop coke much? 🤔

Very helpful . thanks