Stumbled across your video today. I'm the one who made those snap-on grips for the neutrona wand! Thank you very much for linking to our shop and the Cult3D link too!
I switched the molded wires on the 'damaged' part of the hose by cutting the mold off, and stuck real ones in. I took the cable sock off, and bought the type used in the movie. I painted the under wire. I painted the wire parts of the cyclotron using paused screen shots. The rest I left as is.
I also painted the cilindrical part with the warning sticker silver as well. Maybe a few other small changes, including the Alice frame were also done. I got my neutrona wand before they put the ones out with the orange tip.
Very cool. I used a 3D printed bit for the front grip on the "wooden" bit and also cut off the back grip and used a 3D printed grip there as well. Covered both in black hockey tape too. I need to replace those clamps, they look snazzy.
I was going to mod my Haslab, however, Spirit came out with their full sized GB1984 pack, so I will keep it stock and mod the less expensive pack instead.
Thank you! So the end that plugs into the cyclotron just pulls out. The end that is attached to the actual pack though goes through a hole and then is attached somehow to the inside of the pack. You’d probably have to remove the backside of the pack to access it. Hope that helps!
Hi there, that section that I cut out, there's a hard plastic piece underneath that I believe protects the cables running to the pack. I'd suggest leaving that in and just pressure pushing your new wires in. Hope that helps! Check this section out: ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-KkadMlNUeI0.htmlsi=Ut6Syc_c5LV_Vqi2&t=887
Hi sorry I had turkey on my brain. The outer dimension was 3/8 but it’s actually an M4 washer. Try this link www.homedepot.com/p/Hillman-Stainless-Steel-Metric-Flat-Washer-M4-Screw-Size-4118/204801237
Probably. I actually am starting a new list of things to upgrade like adding the “always on” circuit and maybe adjusting some of the lights. There’s a part two in the future I’m sure haha.
