SM GPS Logger - Stand-Alone Modification 

In this video I will show you how I made a stand-alone modification of my SM GPS Logger 3 from SM-Modellbau. The GPS Logger 3 is used for RC models and normally intended to be connected and powered by the telemetry port of the receiver. However I had the need to use it in a stand-alone mode powered by a small 1 cell LiPo battery. The video will show you in detail how I made this modification.
The list of all used material and a link to my free STL files for the 3d printed cases is provided below.
For more info about the SM GPS logger 3 check out the website of the manufacturer SM-Modellbau: www.sm-modellbau.de/GPS-Logger-3
Links to the free STL files:
Case for stand-alone mode: drive.google.com/file/d/1V-Pr...
Small case for standard use (connected to telemetry channel): drive.google.com/file/d/1B08J...
Print settings for both cases:
Layer Height: 0.2mm
Infill: 20%
Supports: On
Note: If your case will be exposed to sunlight I recommend using white filament. Dark filament (especially black) will heat up a lot in direct sunlight and warp the part (main risk is for the cover of the case)
Material list:
- Lipo battery 600mAh 3.7V 1S 30/60C, Size 44x 25 x 8mm, www.mylipo.de/Lipo-Akku-600mA...
- JST XH 3 pin mal and female, amzn.eu/d/9U63deB
- JST SM 4 pin female, amzn.eu/d/e5VIoSi
- Servo wire 0.14mm2 (AWG25)
- Shrinking tube diam. 1.5mm to 0.5mm
- Shrinking tube diam. 3.0mm to 1.5mm
- Velcro tape (width 20mm)
- Electric Tape white, amzn.eu/d/d6Ov2o5
Camera:
Sony HDR-CX730
Microphone:
Rode NTUSB