Sovol SV01 - Build, Bed Leveling and Filament load 

Ah... I thought bed leveling was against gravity before this video... and for that I bought a cheap level. Thanks for the upload.

Thank you very much. That helped me a lot. Greetings from Munich

I couldn't see the "Z sides" well, but if there is a gap between the letter and the rest then the esteps are probably set too low. I noticed it on mine and also read it on many people in the fb group. You can look up esteps calibration, it's recommended to be done anyways, even if the print turned out fine.

💕👍

thanks for this, could you maybe put a video of the next steps up?

Thank you for this. The instructions are a bit unclear especially when you get to the plugging in the boys.

I can't get the filament to feed through the filament detector.

can someone please help me? after i have leveled the bed perfectly. The print will start but somehow the hot end is to high all the way around the bed and wont go down even after i have leveled the bed repeatedly! it keeps going about a half inch to high off the bed. PLEASE help me. I have a sovol sv01

The fanduct is deeper than the nozzle.....something gone wrong!

I have a problem with mine saying that the heating failed, does anyone know what I did wrong?