Spark Timing & Dwell Control Training Module Trailer 

0:29 Peak cylinder pressure is not at TDC, if the engine was being cranked over with the ignition system switched off then yes peak pressure would be at TDC, the mixture is ignited before TDC in order to allow time for the flame front to create peak cylinder pressure at around 14-20 degrees ATDC, this give the pressure the best overall conrod angle to create torque at the crank. In fact the graph shown at 0:34 is correct, you can see peak pressure is AFTER TDC. (There is no 'x' axis info on the graph but you can see that it is ATDC)

Nice video Clit.

so the time it takes to burn gives the angel of the crank by the time its done

I want my 1:52 min back...

Dear Sir Thank you for your information about the ignition advance operation I am now writing a microcontroller for ignition advance control for my BSA lucas system to replace contact breaker

in a world full of free information you will be left in the dust.

Thanks 👍

Thanks.

Pick-up coil is in the angle position of the crank? or the timing of the F-Mark Crank case of Magnet is given on any side of the pick-up coil magnet ?

Really very nice Nice video clint

I feel like I should get paid for watching that.😂

Ok sir

Dear sir, could you explain what stroke overlap mean

Many thank's

Lol.. the ending.

Thank you sir. ..

SIR!if given that set up what would be the Degree when its reach 10-13k rpm?

Not to Dwell on it, but where was the dwell info?

My engine is knocking just on low rpms. That mean that I advanced my ignition point just a little to much? I mean, am I on the edge zone?

Hi ! My stock 2009 1.25 Fiesta's timing advance jumps from 4-15° at Idle, is that normal ?

that's the craziest shit I've ever seen witchcraft off with his head

WHERE is dwell time information???

Bingo....so at 13k rpm the combustion degrees is like 24°btdc ...

Sir i want to know how much? Cost for membership

Clickbait rubbish.

Tried to click into showing insecure 😂

in hindi me

You guys definalty earned your dislike, this information is free elsewhere thanks