INSTRUCTIONS, PLANS & PHOTOS: bit.ly/2r8L2zi
TOOLS & EQUIPMENT (Affiliate):
Sliding miter saw: thd.co/2zGdOaK
Cordless drill: amzn.to/2JS2n4p
Speed square: amzn.to/2SYRqCl
Pocket hole jig: amzn.to/2RMj5ox
Parallel bar clamp: thd.co/2DdQ1lZ
Face clamp: amzn.to/2DxdL5t
Circular saw: thd.co/2AYhV42
Circular saw guide: amzn.to/2DaNUiR
Trigger clamps: amzn.to/2JTIc6j
Glue bottle: amzn.to/2AXQGGA
Brad nailer: thd.co/2SXwtrD
Forstner drill bits: thd.co/2Fcl5oR
Air compressor: thd.co/2zKxpXA
Bluetooth headphones: amzn.to/2AXQJSM
SUPPLIES & MATERIALS:
Pocket screws: amzn.to/2Dx4daE
Wood glue: amzn.to/2Dh0A7E
Brad nails: thd.co/2zGrLpg
Pocket hole screws: amzn.to/2qFLqSc
Polyurethane (satin finish): amzn.to/2qFLscM
Foam Brushes: amzn.to/2AZgemV
Neodymium magnets: amzn.to/2DevHkA
Casters: homedepot.sjv.io/Vm0vj
I tirelessly searched RU-vid and Pinterest for workbench designs, and after taking into account the tools I have and the types of project I work on, there were essentially three main features I needed:
1. Mobility - Hauling tools in and out of a garage is tiring and it eats up time during a build. Plus, if you’re like me, your garage is not quite a full-time woodshop, so being able to store a workbench to the side is a must.
2. Size - I needed a workbench that could accommodate the largest material I might find myself working with: a 4’x8′ sheet of plywood. It takes a large workbench to act as a decent out-feed table for a table saw or to provide an adequate work area when assembling larger projects.
3. Modular - A good workbench should be able to change with your needs, so I designed this workbench to either be two smaller halves or one big work area. I also built-in a slot to accommodate a variety of fixed tools such as a miter saw, pocket hole jig, router table, etc.
I have to give credit to Steve and Bob for providing me the inspiration on this workbench. Be sure to check out their videos:
• You Can Build This Stu...
• Simple Modular Work Ta...
#woodworking #workbench #DIY
11 мар 2018