Tinting your Taillights the right way with VVIVID+ Smoke Air-Tint 

Does it change the brightness of your headlight?

@@MAC35REM Yes, we don't suggest using the dark tint on headlights as it does reduce the transmission of light BUT a light or subtle tint will not be very noticeable. If you have headlights that are generally not bright and you drive a lot during the night(i.e work like deliery etc) maybe no tint should be used just in case.

@@VViViDVINYLS - I ended up using the Vivid Clear Hex, rainbow colors on my headlights after a restoration I had done. They came out fantastic and the film was great to work with. I am so happy with the results. The Vivid clear hex vinyl colors show beautifully during the day and at night. Thank you! 😊

Did you use a heat gun? Do you think a hair dryer would work okay?

@@sittingindetroit9204 No, just invest in a heatgun. Sorry, the the blow dryer doesn't work well for the job. You can find some for a reasonable price.

@@20tea thanks

About to go do my 2019 ram 1500, wish me luck

I'd like to see someone trying to tint the elantra N taillights 😬😂

i'd like to see someone do the 22' Impreza

same thing with Acura tl

Try my Tacoma lights lol

Amazon is the best place to look

Try tar remover- I went through the same issue with removal a week ago (entire tail light covered in glue) and Carpro TarX got it off completely.

just refinish the headlights .. should only take a a few hours....

Goo be gone worked just fine

It depends how large the crack/damage is. If you’re able to completely cover the damage in a way where water would not infiltrate, then it would definitely work! Cheers

Usually you can rub it off with a finger or wipe adhesive remover like goo gone and wipe off. Let us know!

There is generally no adhesive left, especially on the newest versions. However it depends on the type of light and the heat created by the bulb. Constant heating and cooling over an extended period of time may loosen the adhesive - this is true for any vinyl.

Totally agree. I took mine off after one year and it is full of residue.

The adhesive on VVIVID compared to other brands is low initial tack, it spreads stretch over a large area so you dont see lines. The only times you risk glue lines is when heating the film and activating the adhesive to full strength ( or installing in the heat) and/or leaving the material on a surface for an extended period of time.

i wouldnt because its harder to get a proper stretch and a tight fit it will pee

heat and a small tool to push it down around the letters

It's easier to leave it on as it is anchored down and you can pull/stretch the film in a way that is manageable. Great question though!

Maybe if you take off the taillight, then make a firm wooden structure, put it in your vice, and then bolt the lights to it, and then tint it..... I used this tint for my 81 Camaro Z28 T-Tops cause they were scratched pretty good. The overall effect was awesome. But, since it doesn't have a peel protection layer, when I installed it with a credit card and trying to get some bubbles out, I scratched the tint a bit. (rookie) I got more tint and better tools to install. Will attempt it again soon! Gonna raise the temp up in my garage to assist in the installation process. The first time I did it, the only T-Tops were on my table. Pain in the ass. Now they will be on the car forsure!

It is slightly sticky without heat, when you heat it up it activates the sticky side and that's how you get it to stay more permanent.

Jesse&Baylee _ Good to know, I’ve always used water as a lubricant whenever I tinted small pieces. I guess this is the new generation of tinting? Lol

Just did it with a hair dryer no problem

Generally no, but it's always possible depending on the type of light and how much heat it creates. Constant heat for 3-4 years can create some adhesive residue that you'll have to rub off.

A pain to take the residue off. After a year and driving only roughly 6000 kms a year with 25 Kms daily.

Uditha Bandara dude stfu it’s not illegal here and is not ugly

Fuck your ugly as shit,

I'm here vewing & learning for an off road only vehicle application (snowmobile) ....why are you here watching these and commenting if you don't don't want anything to do with tinting things?? D-dag.

@@11x on road or off road if it is illegal then it is illegal and just mind your freaking business.

@@11x just shut the fridge up and will you mind your own business you freaking basket.

Troll

@@kevean20 just shut the fridge up you basket. You beach don't know how many times this illegal video pops up in my feed. Really I was fed up. Just will you mind freaking your own business will you.

@@kevean20 am I the one trolling or this video over and ober in my feed? ... Will you mind your own business and shut the fridge up will you. Really I am flustered with your freaking comment because it is the right opposite what was happened. In the other hand the application of any tint laye over a indicator is illegal and the light shuld have minimum lumans difference when lit and none lit. Please refer the code in your state. Here in DC this is illegal

Typical liberal Californian. You’re ruining the world. Period!!

Cool story bro . So is driving 36 in a 35mph zone SMH