Today I will walk you through the carnage that rats left behind due to neglect. Project supercharged Tork Tech 2 valve is back underway. Like, Comment & Subscribe! DO MUSTHANGS!
Man that really sucks! I always complain about my outdoor cats that sleep in my garage at night but they are good at keeping the rats away. Best of luck
I have the same kit on my 2000. It was a bit of a pain to install with my level of abilities at the time, but it is still a fairly unique build route and the termi blowers are cheap.
Exactly! I am a positive displacement blower type of guy myself. And with the tork tech kit any blower that a cobra excpets these 2v will accept. Sky's the limit.
Andrew Montgomery Hey I also have a 2000GT as well I’m really serious on buying this kit, the kit costs $2500 but how much did you put into the supporting mods (supercharger,fuel pump, hoses, etc.) and dyno tune?
Breathless Boarding so that’s where it can vary a lot of course, depending on if if you’re looking for just ~400rwhp or you’re trying to make more. On Tork Tech’s site they have reasonably realistic prices listed for how much each of the accessory parts (like the Bosch intercooler pump, the Ford lightning MAF, etc.) should cost new and used. For the termi blower, I paid 750ish, which is on the high side for sure but it had relatively low miles and I’ve had no problems since. But, you can get the blower for much cheaper as well. Additionally, I upgraded a bunch of stuff during the build as insurance and pretty much overbuilt the engine (fully forged rotating assembly for instance). Below is the link to the Tork Tech page that lists all the needed additional parts and suggested prices: www.torktech.com/faq-1.html
If you play your cards right and are patient you should be able to get everything done for about $4000. These kitsch are awesome because any blower the 03-04 cobra uses are compatible with this kit. Obviously internals will need an upgrade. I have seen people (yt) claim 500 how on stock motor, but that is up to you to decide how hard to push it.
Andrew Montgomery Thanks for the Info, I can’t wait to start keeping with with coyotes I bet it’s the most fun ever. I’ll be pushing around 415 crank because I won’t have enough to get forged pistons and rods
This car has the most potential why in the hell you dont have it in the garage over that rust bucket I will never know rats hate dryer sheets and insecticide Irish spring soap all work to keep them away sad.to see the carnage
Sucks but a lot of that comes from living in the country . I try to at least spray my shit off once a week . Go through your wiring good. Hopefully you've caught it before they got into the dash or round the firewall bad.
Thanks guys! I didn't really want to do anything with my 2v besides be my dd, but I want to do this to it. What's all needed? Like everything and cost?
AndrewSVT 2200ish for the kit from Tork Tech (just go to their site), plus the other components you have to source for yourself that are clearly listed on the site as well. You can do it pretty cheaply buying all used parts, however you may want to look at upgrading a host of components in the engine and driveline as a whole to deal with 400rwhp www.torktech.com/termi-gt-kits.html
