Toyota Highlander Rear Turn-Signal Replacement Upgrade 

Glad you found it helpful! Are you going to do this too?

@@DansWay I work in electronics I love watching about cars! I still don't own a car 😅

Hey, then check out this video. It is a mix of cars and circuit board rework. Let me know what you think! G37 Instrument Cluster Backlight LED Rework ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-V1488VR0W6Y.html

Hey there! I now have links in the description to get the turn signal bulbs.

@@DansWay what made you decide to go with the Auxito bulbs versus other ones? Is it because they are inexpensive on Amazon? Or did they sponsor you a little bit to do videos for them? Because I actually decided to buy some Auxito bulbs due to the price on Amazon and due to your videos so I can try for myself and see if the quality is decent compared to say Sylvania, Philips, or even Morimoto

@@wutdadilyo I have used a couple of different brands in the past, looking for something more affordable than the 'name' brands. Auxito reached out to me to try a set of their bulbs and I was genuinely impressed with what I saw. I have been using their bulbs for 3+ years now and each one has a better build quality than the 'others' I have tried or been sent. I have been given bulbs from 'others' to try or make vidoes about, but their quality just wasn't as good as Auxito. So are there better brands out there, perhaps. But I haven't had any serious concern with Auxito. I have had a couple bulbs die on me almost right away (first month or two), and they are quick to replace anything defective. I would attribute that to some defect in manufacturing or material. The other 90% of the bulbs are working fine, and people are not commenting on my videos about how their bulbs are failing which gives me confidence to continue promoting their use. For the price, I'm getting a good product with a good warrantee.

Haha, thanks Ridwan!

Thanks Orlando. Did you upgrade your vehicle yet?

You're welcome! 😉

Yes, I need to install ballast resistors to stabilize the blink rate. Once I get that done, I’ll post an install video on that process as well.

Thanks for the info!

I’m working on that one as well.

You may need to install a load resistor to fool the car into thinking it still has a bulb installed.

@Swim Fan thank you for the response. I did end up using load resistors. I would have preferred replacing a flasher module, but the resistors took care of the hyper flash. Wasn’t hard to install.

Ah man, bummer... Looks like you need to either install the external resistors, or use the ones that have a built in resistor. If you contact Auxito they could either send you resistors or swap them out for you. They are very supportive in my experience. Check out this video on the built-in resistor version: ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-2EsXOHfCf7U.html&lc=UgxtIgG1nmwnHUylTot4AaABAg&ab_channel=DoingThingsDan%27sWay

Here are the bulbs that have built-in resistors: geni.us/TurnSignal_ResistorLED