Troubleshooting : Emergency stop button  

Greetings! Thank you for your enquiries. You got 2 MPU , one of the sensor is responsible for your starter motor while you cranking the engine, as soon as the engine starts the sensor sends the signal to the GSC the GSC cuts the power on starter motors relay meanwhile the starter motor disengage. The second MPU is monitoring the engine speed when you loading the generator the RPM drops and the GSC (Genset Controller) accelerate the engine through the LCG. However some engines have only one MPU but twin are more reliable.

You're welcome!

Thank you

Greetings Thank you for your inquiries I'm wondering if you could tell me about your Genset controller First I need to know about Genset controller and then we need to finde the event code , after that I can tell you what problem you have with your generator.

@@northjayhoon9789 deep sea electronics DSE 8610 MKH

@@northjayhoon9789 Engine all parameter shown on ( Enercon Simatic HMI)

Kw fault code can be displayed on generator overview It tells us the generator was overloaded Calculate the current on generator overview parameters when it is fully loaded and then check the maximum current shown at your Genset ,if it is loaded 100% which mean you need to reduce the load It should not be load more than 80%

Thanks a ton Sir.