Good job, you took your time, lighting and viewing the video were perfect, and from watching your video - I discovered that my floor is uneven and the toilet moves( I go for a ride every morning).
I use just an average wall anchor and tap it in after I drill it out. They sell those at the hardware store as kits with screws in the kit. I hate to tapcons.
@@CP-nf9my Thanks for mentioning that will help someone who reads this comment. I have used composite shims. I think that I said something about that in the video. Thank you for sharing.
Hi Stan, Thanks for watching. If you look closely on the corner of the flange you will see that all four corners bend down and out where I put the screw's through.
@@fixitjohn okay On.mine the flange is flat I was actually heading out to install it in a 100 yrsr old house when I commented. Ended up that it didn't matter Everything was so far out of square spec and whack I had to improvise. Ended up using one Phillips tapcon, one sheet metal screw and two deck screws of different sizes. But it looks good from my house
