Weak Blower Motor Fix 88-98 Chevy Truck - AC/Heat Air Flow Diagnosis 

1999 k2500, I pulled the blower and with a tooth brush and soapy water in a spray bottle. There's a opening at the bottom so the water leaks out , you can see it fr outside the vehicle. Sprayed the inside with yard hose. Sprayed soapy water. Light scrub a dub. Rinse. And it looked and operated like new. I did have my daughter (tiny hands and arms do the scrubbing) to be fair. Thanks for the video.

You can also remove cowl vent on top towards the firewall and vacuum all the leaves , debris whatever might be blocking your air from entering your fresh air into the hvac assembly. Also clean the drains that exit towards the engine compartment. One just below the coolant overflow tank and the other on the opposite side same location. Hope this helps y’all also. 🙏👍

You are so smart, this morning pulled blower off, not easy, same thing with that top bolt but I got it out. I was looking for the grid evaporator to clean it as my blower could blow higher. shoot didn't know it was to the left. 98 Silverado 1500. will do when it's cooler. probably my seals are old too. ty God Bless

I did the same things you did but went a step further. Layed a large trash bag on the floor, sprayed the evaporator with simple green and let sit for an hour. took my water hose with a hose end sprayer and literally washed out the evaporator.and this also cleared any left over debris out of the drain as well. Works like new

He did a great job explaining and showing. Much appreciated

You've got a really good way of explaining things. I consider myself mechanically inclined but I have a much better understanding of how a car's A/C system works now.

Well done sir. Thank you for the details since i know nothing of this stuff LOL

Consider instead of degrease and water, set vent setting knob to face/upper body, take dash off, take all vent registers off and plug all but center one with rags, take blower motor out and get in there with appropriate brush and while brushing put nozzle of strong leaf blower into center nozzle. While you're brushing all the stuff you knock off will blow out toward you. I did this and got a perfectly clean evaporator.

There's even more you can't get to. The best, and hardest, way to take care if it is to pull the HVAC box out, which requires pulling the dash. Then replace the evaporator. I would advise replacing the actuator motors also if you do. Definitely put a fine screen on the outside to catch this stuff before it gets inside.

Good video a lil too in depth for me but very informative nice job cause I suck at wiring lol oh quick tip of the day a toothbrush or soft brush lay some towels in the floorboard and stick a water hose in there and blast it it will come out of the water drain underneath if not you can use hose to unclog it.

Great video James.

I was hoping to easy an "after clean" shot of the evaporator. I have a 1990 silverado and I am going to have to do exactly yhe same thing. If it is really bad, I may go ahead and pull the whole box out just so I can get it sparkling. Thanks for the video!!

Really good video brother. Thank you

Great video, i have the same issue, thank you

thanks for showing me how the clean my blower in my 97 tahoe !!!!!!!!!!!

You forgot to show if the tissue you had in the beginning is blowing harder after your cleaning...

Thanks for the video Brother!

Great video!

A cheap multi-meter can be bought at Harbor Freight or similar store. Usually under $10 and will work fine.

I have a 92 Chevy k 1500 Silverado this morning I removed my blower motor and jam the Shop-Vac holes in there it angled it around the best I could and I took a picture afterwards and it looked completely clean it was just as dirty as his. I haven't tried this but I wonder if you could shove a cabin filter in through the blower motor hole just an idea but regardless my heater is blowing better than it was I would put it on recirculate I can feel all the airborne back out to the event by the blower it's supposed to be sucking air in

Use an old soft toothbrush and a good cleaner like Simple Green to clean the evaporator and spray with a garden hose on low pressure with a spray nozzle on a wide pattern .protect your carpets with old dry bath towels. The drain should drain any water to the outside under the vehicle.

Very informative..... only silly question is why didn't you remove the glove box. Heck of alot of room with it removed.

Tested mine. 11 with the truck off and 12.3 with it on. Both times on full blast. Does that sound good, I’m having weak flow after resealing yo my lower damper and cleaning behind the blower.

My blower fan stoppes working. It would work then barely work then i hit it with a rubber hammer and it would work but now it sounds like it turns on but isnt blowing any air at all. But you can hear it turn on. Going to try what u did and take it out to see whats wrong

im watching so far so good 7 min..

Thanks for sharing

Why not use evap cleaning soulution and wet dry vac?

I’ve got a 97 GMC sierra. When I first start up the truck and turn the blower switch to high I get a little bit of water spurt out to the passenger floor. Is that it AC drain pipe issue? I’m trying to diagnose an intermittent overheating issue with this truck. I have back flushed the heater core I replace the thermostat I replaced the temperature sending unit I replace the coolant temp sensor and I have no leaks. But intermittently the truck will start to overheat and the hot air will turn cold. Eventually it straightens out and it’s fine but I’m still scratching in my head as to why this keeps happening I don’t like having to stare at the temperature gage while I drive the truck out of fear it may start to overheat. Hopefully I can get some good information from you and others I’ve asked. Thanks. Man!

2-04-2022 Get a large sheet of plastic cover the front passenger seat , center console , front floor and be prepared to get wet it's just water. Spray purple Degreaser on it and brush it with a bathtub brush and get the garden hose and spray water in from the opposite side or ,either side for about 5 minutes it will clean off.

Muy bien amigo gracias 👍🤝

Great efforts ..much thanks for sharing

Do I need to pull a vac on my AC and replace freon after replacing heater coil?

Myy 99 burby is not blowing hard at all,any video on how to replace air filters under dash?

I have mice in my 1991 caprice evaporator. I took off the blower motor cause It was bad and there was a lot of nesting and poop also in the resistor area i have not checked the heater core area but I’m guessing there too because it still smells

Thanks for your video.Will help me on my 1990 chevy.Thanks again.

see I think this is the issue on my truck, but my dad thinks otherwise. The fans arent blowing very much and it takes a bit for the high to actually kick on compared to the low or the medium setting. its a 1992 silverado and ive never been in any other one. im just not too sure if those trucks are just weak with the fans or its just the motor blower. some fans sound like they are puting out a lot of air but the center two are not, or sometimes all of them are just weak, even on high they are weak.

Javaman did u figure it out im getting motor heat on inside

What size are the mounting screws to the blower motor?

I have a 1997 1500 Silverado and when you turn ac on there is a clicking noise in front of moter at fire wall there is actuator that moves when you hit ac and it starts clicking you turn ac off it moves and clicking stops also going to clean for better air flow

If I dont hear my blower motor then in your opinion it is most likely it needs to be replaced. Everything else seems to be working my blower motor is not kicking in. Thanks

Soooooo the conclusion on the blower motor. Was it weak after all? Because when you wrapped it up, you should have said that the blower mower was part of the problem and their was a restriction at the coils also.

Use a soft bristle tooth brush with your favorite cleaner to clean out the condenser. I use Greased Lightning to do this along with a towel under the condenser. Fold the towel sever times to catch the overflow from the hose pip. DO NOT GET TO AGGRESSIVE with hose pipe.

Thanks for the video,i have an 88 blazer and every so often i'll be driving and my ac will stop blowing and no air whatsoever will come through the vents and then come back on after awhile,and i was leaning towards the low pressure switch on the accumulator but one guy said it actually might be your blower motor,any thoughts?

There is a video on RU-vid called '96 Yukon 88 to 98 OBS Chevy GMC evaporator and heater without removing the dash there you will see how thick that evaporator is..........

I just cleaned mine out and tested the fan which spins pretty well still no airflow

Have you ever run across any problems in these your mom pickup swear the AC is engaging has plenty of fluid wants to get cold but it's not. Almost act like the HVAC control module for temperature control is not working and is stuck half cool half hot vi Vehicles AC going down the road is only approximately 65 degrees

I have a 98 Chevy Silverado my ac not going on high wat could be the problem

FYI: The Heater core Box cover is easily removed on the 98 Silverado,

Oh yes, removing the heater box is not an easy task (for my truck at least), the first step requires going to someone that can recover the refrigerant. On my 90 Silverado the dash is a nightmare to remove. It helps to have two people. With older dashes, most likely, you will break stuff so have a plastic welder to fix them. New foam seals can be had at LMC truck or weather foam cut to size and put down with spray adhesive. Any AC lines you disconnect, bag and zip tie the ends to keep crap out. Once the dash is out get your heater box out. At this point why not just replace the Evap and cap the ends. If you heater core looks like it has any pin hole leaks replace that too. You really do not want to go in again do you? Also while the box is out remove the top bolt of the air door actuator and throw it out. If that actuator dies it is damn near impossible to remove with the heater box installed and works perfectly fine without it. Reinstall the box and dash. Let the person who recovered your refrigerant hook everything back up because you will need new seals then they check for leaks plus they will know how much compressor oil needs to be added back into the system. Note: The Haynes manual for this vintage of truck states you can remove the heater box without taking the dash out. Well for a 1990 k2500 4x4 Silverado if you can do it my hat is off to you. I just got done doing this so order your parts first and give yourself a solid weekend and keep sensitive ears away from the cussing. Great video. Cheers.

I'm getting hot engine compartment air blowing in. It's coming downwards between the blower and kick panel. Any idea what I need to do to seal that up?

Mi chevrolet cuado lo pongo en la ultima velocidad se apaga el compresor, le puse el sistema de los botones nuevo y sigue con el mismo problema

Taking the glove box off helps with more room to work

why did you not put the paper towel in front so we could know how much it fix the issue ..you feel me . the ending was bad

Curious . . . where did you go to high school .

Easier than on a 89!

My ac not going on high wat could it be

Replaced blower motor resistor and blower motor changed switches only have high and low no intermediate speeds

I thought somebody hid the pot and forgot

I have a 96. It usually takes a few seconds for mine to start blowing. Now the weather is 19 degrees and it stopped completely. Can it be frozen? 🤣

I have 1998 chevy tohoe I changed the acuator and temp control with thermastar and water pump and still get no heat whats the problem

Pretty sure there’s supposed to be a cabin air filter in front of that evaporator.

That's the heater core, E vap is on the other side

my blower on my 94 draws a shitload of amps..

Relay maybe. That was my problem.

Never hardly use my vent setting in my HVAC. Roll windows down or run the A/C.

8:15 queso

Gmc screwed its customers on this cleaning or changing

88-91 not even the same

I used my wife's toothbrush.

Did you give up man making videos?

It's weak because it's a chevy piece of shit

Or, just go to local cliff and push piece of shit chevy truck over the edge. Unless your chevy truck has decided to lock you out while vehicle running. Then you will be forced to ask a Ford owner to push for yourself

Engineering at its finest. Chevy trash No wonder Obama bailed them out