Welcome to Guns and Gear Network the channel dedicated to bringing you information, knowledge, and reviews about guns, gear, outdoor products, prepping, survival, and self reliance. We encourage you to participate in our channel by sending comments, sharing our videos, and subscribing.
Maybe if you remove the belt clip on the back of the radio that will allow it to sit further back in between the side holders and you might not need the paracord. It would be easier to access the buttons
I was going to go with the 6112 front and 5100 rear Bilstein but my off road shop instead suggested I go with the Old man Emu setup shocks,coils ,upper control arms , rear leafs etc . I have a 2016 Tacoma . I'm very pleased with the result !
Check out our Amazon Affiliate Store www.amazon.com/shop/gunsandgearnetwork for many of the products we review, use and recommend. There is no additional cost to you and it helps support our channel. Please share our videos and other 2A friendly gun channel videos to help get the word out and fight the silencing of our voices. Don't forget to Like, Share and Subscribe!! LINK TO PATCH KIT tacticalgearjunkie.com/collections/embroidered-patches/products/preppers-patch-pack-10-piece-set
I’m like you that I have been searching for bad reviews or at least problems people have had. I can’t find any either. The cost of the gun is kept low due to direct sales. It would cost a lot more if distributors received a cut as well.
It seems that most Toyota models over the last 10 yrs or so can developed trans clutch slippage. I have a rav4 and camry and both developed trans shudder around 90k miles and the problem went away in both cars after changing the trans fluid. If you own a Toyota, you would be smart to change your trans fluid every 80k miles or so.
Being an old skater, I got grip tape on everything my bass drum kick pedal my high hat pedal my bic lighters. I got grip tape in every color, you can imagine tiger stripe lightning bolts on my shoe on my guitars in my cars, but not on my carry That would eat a whole through my back, my side or my stomach, maybe if I had one of those shoulder straps like some old private investigator. It wouldn’t be too bad… but I’m building a competition gun. That’ll probably get some grip tape.😂
@@GunsandGearNetwork you’re correct however many comments suggest vinegar if one doesn’t have ammonia so wanted to emphasize no vinegar. Keep up the good work mate
Not enough info on what materials used to make, not enough focus on the camera on the mounts to see what was used, nice set up but the camera moved too much to really see the set up
Hello manI am looking to change out the recoil spring in my MAC 9. what recoil spring kit do you recommend I can't seem to locate any for this pistol.😎
That is a great DIY stand! I am going to make a couple tonight! The only thing I may do differently is put the 1/4" top tube outside of the back of the panel frame so I can bolt it through both sides of the tube and use a lock nut on the inside of the panel frame...May be overkill but I will see how it works!
I test drive a2010 and I felt it at 50 mph it wasn’t too bad but I didn’t like it. It also would shake the steering wheel at 70mph . Had some oil liking underneath on the oil pan. Otherwise it run great. Should i buy it anyway lol .
Do not buy digital night vision you will regret it. Get a pvs 14 save your Penny’s out $400😅away a month until you can afford one. If you can’t put 400 away a month then live within your means stop eating fast food make more sandwiches make your own coffee. Work another job if you don’t put in at least 60 hours a week and you’re still struggling it’s your fault. 20 hours a week at $15/hr is $300 extra a week that’s $1200 extra a month. Do that for 5 months and you’ll be able to afford some badass kit.
@@mattmurphy7030 I agree you could buy ceramic body armor, plate carrier, ballistic helmet, and digital NVG for less than PVS 14 and still have money left over.
