1855 Remote Removal and Install 

Hopefully we all live that long. 😂

@@ThatOliverGuyChris😂😂😂

Thanks!

Awesome! Thank you!

I already had that bolt out to clean behind the platform support, so I got lucky once again!

You sure did. It was only about a 2 hour ordeal. Sadness was a theme that day😅

Now you have to get a rops!

Thank you! You too!

It did come out a bit short, but it acts like it's going to work ok. I'm going to bolt the console down and give it hell to make sure it stays engaged.

Thanks. I sound like my acting skills have improved. 😆

I thought I had that and putting a new oring in the fitting where that line connects. Not sure where that footage went, but when a tractor is as bare as this one, it's pretty easy to install.

I've seen loaders tapped into that port. It works, but there's better ways to get the job done.

@@ThatOliverGuyChris I would want the highest flow, coolest oil for any loader work!!

I bet that makes a big difference.

I think they should. You'd want to have a pto pump to run the fan on the planter. I have a friend that pulled a 6 row 5100 with his Super 88. If you have some steep hills it could be a challenge, but other than that I don't see why ot shouldn't work.

@@ThatOliverGuyChris thanks for the reply!

Did I say that? I do tend to mumble at times. LOL

Thanks! The float valve was an option. My 1955 has a float, but my 2255 and Alan's 1755 do not.

We had 3 on our 2-105 without any problems, but we made a U shaped bracket to mount the 3rd set above the 2nd. .

My brother gave it to me for Christmas. The brand is Suptig, and I think he bought it on Amazon. I added the magnetic base. It's small and bright, making it very handy.

New Holland yellow is close, but not quite perfect. Oliverdecals.com can make you a new serial tag. They'll need to know your number so they can stamp it in.

Thank you for your help

The parts book has it as part number C358A for the water pump packing seal. Unfortunately they don't give a size and it's discontinued, at least through AGCO. Your best bet is to take it apart, measure the shaft and bore area and see if you can find something that will fit in there. The fan belt is a C372A. I was able to find a few places online that sell replacement belt by search for "c372A oliver belt" Check out this link. Even if they don't ship to Tasmania, they have a list of all the different models it fits, plus the dimensions of the belt that will hopefully help you find something more local. www.tractorpartsasap.com/belt-fan-new-case-02696ab1-a26660-t5031-108776.html

@@ThatOliverGuyChris thanks for your help I’ll check them out. Kerry.

Have you tried Shoupparts.com ? They have lots of parts with measurements for hole spacing, wisth, and so on

Normally I step over a dollar to pick up a dime. What did I say?

No to the 1850, and probably yes to the 1855. They changed the platform in 74 in the way it mounts to the sub frame. The 1755 and 1955 use the same platform and have the same change, so there are options out there.

Ok thank you that helps me figure out what I need to do. With your 2255 if it was just a parade tractor which way would you you have it no cab or have a cab on it.