2021 Supra: JB4 Install 

Neat. I didn’t know about any mounts at the time.

Hardest part is probably passing the wire through the firewall, and that’s not too hard.

The hardest part might be pulling the obdII wire through the firewall.

After a map is selected the phone isn't needed unless a change needs to be made. The extra power requires better/wider tires. I still have it and will probably keep it for a while, no complaints.

@@unleashedxauto thanks good to hear what map are you running?

@@ramanmonkey I keep it on 1, I'll go back to 3 when I get better/wider tires.

Absolutely recommend it. I didn't do a downpipe yet though. I think I may need wider rear tires first. Its a little harder to keep traction in 1st through 3rd while running map 3 (+6 psi).

There's a real good chance I'll get a Z, been awhile since I had a 6speed.

Vr30 trash

This aged well…. Lol

🤣

New dyno charts came out after AMS tunes the new Z on MS109 gas. The turbos are basically dead at 450whp, E-85 would increase power a bit but the curve would still be garbage. Mod for a mod the Supra will blow the doors of this thing. Assuming the ecu is unlocked. For the sake of comparison. The Z did 453whp and 524 wtq with power dropping off heavily at 4500 rpm. The 2 port Supra with the same mods and fuel made 515whp and 560wtq while holding power to redline. These cars are NOT close