No video :(

3D Printing a capacitor Bank for the Diy Electric surfboard.

Подписаться 302

50% 1

Hi i am 3d printing a capacitor bank for my diy electric surfboard. I designed the cap bank using onshape and then printed the first draft using my creality ender 3 v3 ke 3d printer. If you are into Rc models or have an Esc (electronic speed controller) then it is a good idea to add a capacitor bank to help with ripple current/spikes in the electic system. here i am test printing to see if i need to make any changes to the print before 3d printing the final version.

Опубликовано:

23 авг 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 3

@NavalTechTinkerer Месяц назад

Whats the point of these? I get it if you have cureent in rush, it takes some draw of the batteries for a very short moment. But if you have lipo at 12S, isnt that like 45 amps per cell? Thus 500 ish apms peak. Cant you adjust the voltage to the escs from the remot reciever so the escs are stopping at say peak 145A?

@thewaysider7774 Месяц назад

I had the same thought but as far as I can tell there is no way to limit the amp draw it's more to do with the motor kv it's important to check the max amp of the motor some can go higher than mine but I can also play with different props to bring the amps down if needed.

@NavalTechTinkerer Месяц назад

Usually you can modify the voltage, on the controller. Don't you see any settings on the Flipsky remote to reduce the top throttle voltage or similar going back to the ESC?