69 Baywindow. Floor removal. 

This was an excellent video Stephan. I’m watching closely and learning. I really like your approach and thought process. You’re making my new build better all the time! Thank you!!

Were we’re going, we don’t need floors. You’re making killer progress 🤙🤙🤙

Great video with a ton of information. Keep at it. You're doing an outstanding job.

Outstanding video my friend!!! I need the binge watch and catch up on your videos

Great progress!

Coming along nicely Stephan, that sure is the right way to fix that! Great Video!!

Things always seem to work out - ain't that the truth? Thanks for sharing Stephan - it's going to look great when finished. 👍

You're doing great Stephan! 😁👍 Keep pushing forward my friend. Its a shame some of the parts were shipped incorrectly, I hope the company makes it right though. 🔧

Good move on removing floor,will make it a lot easier to tackle the repair jobs. Panels these days are very thin ,hope they all fit ok good luck Stephen

Lots of work, great job !

Great job brother

I would install the jack points. Looks original and will increase value to anyone that knows buses. They are good to jack on and also to attach a side step

Nice

Good job sir

Wow. Thats alot of work. But from seeing your past on the Comet. It will go swiminingly. Good job on the videos. Time for a video of shelf installation in the house garage to get all the future parts onto?

Heyyy bro! Like #21 Looks like your hard at it, man. This van is going to look really good in the end. Keep it up! 💪💪💪

Moving right along,

Hi Stephan,Quit a bit of spotweld removal the floor came nicly out not to much damage may be useble for eventually repairs,just want to mention if you bore out the spotwelds when hitt the outriggers then tje rustpowder came up than it`s time to stop if not you going treu the mettal.Klokkerhols os not the best metall provider never fits as it should lot of extra work.take a peak on BBT,Belgium,they have just the best parts .Further on great progress you douing well🇨🇦🍀👍🏻.Greetings.Hubertus.🇳🇴🇳🇱🙏🏻👍🏻☮🇨🇦

A tool you might want is a spot welder from princess auto, they work so good.

you have a tube for heat, large centre one insulated, small ones are for e brake x2, clutch, throttle, and 2 for heater control cables and the shift tube too

Lots of spot welds to deal with. But it all takes time.

No going back now. You are in it for the long haul. If that one piece behind the front wheel is just flat, why not use it as a pattern and make your own with thicker metal. Keep up the good work. Can’t wait til you clean up that metal. Try using a flap disk. Works better than a wire wheel. Also check out vagabonders. I think he did a flour replacement. I think you’re gonna have to cut all those guide tubes. Or they might sell replacement ones.

I'm amazed how many places are they welded.

you can cut the top hats in half at the shift tube so you can put them in from each side and weld it back together after. There is a metal layer that goes down in front of the first top hat too. it is part of the cab section.

The cross members have square cut outs at the top edge to allow the small control tubes to pass through.

Looks like major surgery 👍