In this video I will take you threw the process to replace the headliner fabric in a gmc or chevy truck, with a fabric of your liking.
I apologize in advance, my footage got messed up when I started to apply the fabric. just insure that the fabric is applied to half of the headliner and complete, before moving on to the other half.
please watch the entire video before pursuing your own project to insure your properly prepared.
thanks for watching and I hope it helps!
I can't stress enough, the foam backing has to be completely removed from the headliner unit before you can apply your fabric. You will be attaching the fabric to the fiberglass located under the foam backing.
-Remove the headliner unit from truck, rip off the old fabric, use a wire brush to remove the foam, use rubbing alcohol to clean the surface when done.
-choose a fabric of your liking from your local fabric store. however, keep in mind that you will want something fairly thin and or fairly stretchy to get around bends and corners easily.
-Spray fabric with light water, throw it in dryer till all wrinkles are gone.
-Drape fabric over half of the headliner unit, get it perfectly lined up and ready.
-Spray the exposed half fabric and half headliner unit with your choice of adhesive, let it dry to the touch, typically 10 min.
-Slowly and gently lay the fabric in place starting from the middle and working your way out.
gently lay it in place until you are happy with the lay out.
-From this point you need to massage it into place starting out gentle and pushing harder as you go, once again starting from the middle to the outside.
-Once you are happy with the results complete the other half of the application in the same exact manner.
-Stay close by for the next 24 hours, keep it fairly warm and keep checking for areas that may have lifted off the unit. simply massage these areas back down with a lot of pressure.
-If, after 24 hours, any areas don't come out so great and you can't convince the fabric to work with you, use a heat gun very cautiously to heat it up and convince it to comply with lots of pressure. BE CAREFUL! you don't want a burn mark in your awesome new headliner!
Good luck.....thanks for watching! Let me know how yours turned out in the comments!
16 авг 2018