A&A Low Profile 6-Port Pool Actuator Rebuild 

I watch this video every year... Thank you

Amazing that you posted this video. My pool company didn’t do anything with my floor cleaning system when they opened my pool and left the parts just laying around. Now I can finish the opening!

Wasted half a day trying to get my Actuator put back together before I found your video... Thank you so much for posting this - back together and running better than ever in 10 minutes!

Thank you. I did not know that bottom piece unsnapped and wasted a good couple of hours until I watched your video. You da man.

Thank you very much. You are the only one who posted a very detailed video on this.

Thank you for posting this video, it was helpful. I watched it two times, when my rebuild kit arrived today, was able to install it in minutes. Especially helpful were the parts on testing the actuator manually and the two small washers to install. 👍👍👍

Thanks for the video - my pop ups were not cycling so I took it apart and the #2 gear in each set had worn teeth on the bottom that were not mating up with the lower gear so since the #1 gear (from outside towards middle) bottom teeth do not connect to any other gear I remove them and swapped positions. Now all gears that mate are contacting. To replace it is critical that the bottom foot is removed from the rest of the unit. I had the same issue replacing the two washers, so I removed the clips on the top gear on each side, removed it and washers just slipped in place and replaced those gears and lock washer. Slipped it all back together and now going through the initiation phase to remove air from the system. All pop ups now working normal. Took about an hour to remove and swap gear but did not need any parts. #magnasweep 8 years old and now running good as new. **Told the wife I could fix myself - LOL

You are the best! Exactly what is wrong with my pop ups...thank you so much!!!

This is great. Thanks for including the link to the parts.

Best install I've seen yea...Thx

Great demonstration and explanation. As John G said, thanks so much

Totally helpful! Thank you!!!

The magnet didn't work because the pin is stainless steel. Thanks for the video.

thanks. very helpful.

Excellent....

I have the exact same as shown. Where do I order these parts and part numbers. Thanks

I have one of these and none that we can see are broken but the ones in the pools don't all pop up. The pool did sit for a few years dry before getting it up and running again. My pool guys still says he thinks it is my filters, but I just cleaned them. We replaced the gear thingy because it was broken. It spins in there but we think that there is a circulation problem. Since not all of the popups pop up. We are going to buy the popups a bit at a time since they are pricy. We have the Caretaker 99 popups that were popped out of their sockets. We will be ordering the removal tool. any tips?

hey man, my metal shaft is not coming off, should I pull it with force?

Hello, I watched your video, but water is not filling the actuator?

Are you located in arizona?