this video showing the actual installation of accelerator motor and way on how to calibrate, to synchronize the normal function to the. ecm. keep on watching
If there is way to acces or to do the same try it, if not you cannot do any thing, catepillar system is not the same with the other brand of heavy equipment
sir insfection nyo muna ung brake pressure like doon s brake valve nya mag try kyo mag open ng pipe doon just for checking kung may nag fflow n oil s brake system nya, then check. nyo. rin ang differential oil level baka nman may internal leak
bro sorry for the late response,about the error,190-8 that is speed sensor located in flywheel,that sensor it eighter sensor is damaging or totaly damage,-8 means inaccurate reading or fulse to ecm,its possible also on the harnes maybe inspect the harnes before you do the replacement of sensor
bro sometimes its because of fuel airlock, or maybe the injector actuation sensor, if that sensor is damage no chance to start, or you can try to remove hose at the return valve, then the return valve try to hold with your finger or put something that will not having pain to your finger while holding the pressure on cranking time try it.
try to used starting fluid, crc or petrol, if still not starting maybe the actuation sensor damage, but you have to make it sure that the fuel is flowing on the return valve, if not maybe some is wrong on fuel pump ok.
sa gilid ng hydraulic pump may dalawang solenoid ung nsa bandang gitna check mo un baka ung wire nya eh walang supply n lumalabas arround 24v ang supply doon check mo muna. contakin mo ako s whatsapp +971567581176 para s mabilis n usapan
pump 1 dsi meaning sensor mo s pump 1 its eighter ung sensor damage or wire damage inspection nyo, harnes, kung low power macheck kyo ng pressure para sigurorado bago kyo magadjust, mag record kyo para maybases s mga pagbabago, or contakin nyo ako s whatsapp, +971567581176
@@caterpillarjhunhunk boss mababa po ang reading na pressure Ng pump 1 around 3111 kpa ang pump 2 NASA 4111 sa #1 rpm.pano po ba mag adjust? Nakita ko kc sa iba Yung nut na 16 mm ang niluwagan tapos pinihit Yung Allen wrench.yung Sayo iba 30 mm ung nut na niluwagan mo.ano po ang Tama?
marami n akong na encounter n ganyan, ppweding walang supply n npasok s power shift mo, or ppwede rin na mataas ang volume ng hydraulic mo, kpag ganyan kailangan mong mag adjust ng flow nya reduce mo
