Converting a Generator motor into a Go-kart Motor (Fixed Audio) 

lol.. thanx i guess... if i get another motor i would show you again, next motor would be turbo'd

It's called a centrifugal clutch, it's cheaper than a torque converter but it will only be geared for one speed. Torque converter changes the gear ratio.

Just good old regular sandpaper.

Look up it's manual online but I have a 168F engine it takes 0.6L of oil.

Did you take that motor out of a generator? If you did, then it should have a shaft that goes to the electrical turbine of the generator. Just remove the electrical turbine and it should have a output shaft.

Legendary Go-Kart Worx, Ha ha I was all set to rip it apart, Unfortunately the Generac motor is like a B&S without an output shaft, The recoil-flywheel-stator side is all I have to work with, Imagine having to tap power from a B&S but only from the flywheel side, It is possible but then I would have to modify so much, ugg! I

Does it have a side shaft output or a downwards shaft like on a lawnmover? If its a sideshaft then you can use it without too many problems. All generator engines will use a sideshaft but I am not sure about a trashpump engine.

I had a look at the trashpump engine and its a sideshaft engine. So it will work for your project. Its basicly the same engine as the one in my vid.

You have to machine the shaft down to get the right size for the clutch.

Yes I am