Very nice new build. Your adjustments to airflow were great. However, those were upcuts from the opposite direction of normal cutting. You didn’t show normal cuts from the front did you?
I think it would get in the way if it was at the front, (i.e. the reverse of the current position) but maybe at the top, so that the air doesn't have such a large change of direction.) Seeing the dust collect in the corner seems to be the opposite of useful. (Like having a cyclone separator built into the device that is designed to collect.)
Helpful. My table saw has a vacuum attachment on the blade guard but the dust extraction is from below. Must experiment with blade guard dust extraction. Thanks for informative video.
You made is smaller thus increasing the air velocity. But you should od put the hose on the top or on the front. You are fighting inertia of the particles and loosing. instead you should use that inertia to collect the particles. C- Design
Im no expert but, if you would have lowered the blade at 0:37 to the minimum height, wouldnt the saw throw out the chips more upwards than to the front?
i think he cut it backwards so the dust goes up and end up above the table, if he cuts it normally most of the saw will end under the table and we wouldn't see so much dust getting sucked to test it's efficiency
