Good video. Did same job recently with same outcome on fan pressure, at -4.5mbar, plus some minor adjustments on gas valve. Interested in how you tested seal integrity, can you say more about the sensor. Thanks again, look forward to next video.
Hello. I recently gave a full service to Worcester CDI. Cleaned heat cell, new electrodes installed, new baring plate and all seals installed. Max and min readings perfect. But fan pressure and gas rate is still less than they should be. What else could be causing these low readings?
ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-GiRo01XDd5M.html In this video he shows how to check the bearing plate and adjust the fan speed. Maybe try that 1st 👍🏽