1st you have to have a button bound to ch3 and ch4 from what I remember then just select it and press the button you might not even have to have a button bound to the channels in the newer firmware :)
Yes but it's a pain as you need a usb converter that allows you to connect a receiver to the pc, it then takes the channel output of the receiver and changes them to usb inputs but you also have to power the receiver
Hello Sir. Is it possible with Nb4/Nb4 Pro to control 2 recievers at the same time? Reciever 1 for the Crawler, Reciever 2 would be in the trailer for some functions there with a separat battery and esc. Thanks
@@WTFRCCars ohh thanks! you were right about the ch3 and ch4 pre assigned buttons. i unset them so they will show 0% and I was able to assign them! thanks alot!
@@WTFRCCars yeah... It pops up but I don't get the calibration (test) page when I hit properties like you do. It's the same like with nb4. Tried different cables... And it works with the mb4
@@WTFRCCars I tried again this morning... Now my PC gets the pro. And i also get the calibration test page with the nb4. But still vrc only recognized the nb4, not the pro. Sent you a video in messenger.
Yeh you need to set the pro as the default windows controller, then open vrc as it's a very old program it need the control set as default before it shows up the 1st fine :)
For the nb4 and pro use the INR4-GYB receiver to have full stability control over throttle and steering :) I have vids on it in the receivers playlist for both pro and nb4 :)