Four Winns Boat Amplifier Wiring and System Tuning - Fusion Stereo, Wet Sounds Amplifiers, and More 

Well guys,what a coincidence, I'm a master boat tech,and electronics installer,like this show guys!!

Awesome job that system is insane 👏

You guys are killing it 👏 🙌

Got the whole spectrum covered .....from Lambo to a boat and the old school Caprice Classic in shop at same time .....hope Caprice videos in the works..

Loving all this content!!!!

Love me some Boats !!!!! We work on atleast 1 per week down here in the South ...

I have the same boat, nice set up. For your info, nearly all boats, the model number is the length. SL242 = 24'.

Class is in session.

Fusion has a hand mic that will use the speakers as a PA system

Haha , y’all cheated on the Yellow Marine Grounds !!! But I like the look of Yellow Techflex

My personal favorite audio company is JBL, I have their PA speakers for my DJ system and I have some marines JBLs in my boat. What is your opinion of JBL?

Anybody have that fusion unit. Hearing mixed reviews on fusion

I wish y’all were in FL. Having such a hard time adjusting gains even bought a $250 fluke multimeter but I guess I’ll have to take it to someone. Is it normal to have a little buzz/hiss sound if I have a jl audio Bluetooth CRXV2?

I have a question about setting gains with the DD-1, and which method should be used. When determining max clean volume on the headunit should the RCA directly from the headunit be plugged into the DD-1, or should the RCA be plugged into the amp with its gain turned all the way down and use the test probes at the speaker output terminals. The manual that came with the DD-1 says that it (Recommends) testing/determining the headunits max clean volume through the amp with the RCA plugged into the amp with gain turned all the way down and using the test probes at the speaker terminals. I would think the best way would be the way that is done in this video with pugging the RCA directly into the DD-1. When I tried doing it both ways I got two different clean max volumes numbers that is why I ask this question.

What batteries did you use for this setup? Curious to know how many you used, what brand, and what size. thanks

What tone did you use for the sub?

Did you guys use the dsp

So the Wetsounds 420 EQ doesn't really do anything other than add microphone capability? Do you just leave all the controls set to maximum since you are controlling zones with the Fusion?

For boats,hobbies car audio installer

And why for all the things that are holy is he using Bluetooth instead of airplay with Wifi? It’s Airplay and DSP that made me spend the money on this upgrade.

Bad spot for head unit. Should have swapped with pocket

Those WET SOUND eq’s are JUNK !!!!! Biggest waist of $$$$$$$. And noise generator around RGB lighting.. just speaking out loud

VEEEEEEERY time consuming install. lots of channels. A ton of work to bring this all together. obviously a good customer paying for quality equipment and a quality install. Def Not a job that could be done dockside without distraction from dozens of nosy marina guests constantly dropping by to talk. been there. i was recently fooled by the DD1 for the first time last month this time installing a system on a Rockford head. DD1 was noting distortion nearly right out of the gate. I thought it was a faulty head because it had previously been running a 2 ohm load on deck power so I figured it was cooked. I had customer order a new replacement head, same result. so I was like wtf and called Rockford and they said that model head was not a true licensed model and had been discontinued. He followed up by saying the DD1 measures distortion at 1%. The moral of the story Is I wasted a lot of time when it turns out it was the head unit signal was not "clean enough" . Since then I started using a scope so I could see the sine wave rather than the led pilot indicator. i still use the DD1 and do love it, but the scope is a nice tool to double check. Very nice work. Love the starboard drop in. Did you use deutsch connectors as well. I wouldn't be surprised with the level of detail you put into this system. Is there a capacitor going in too? How many batteries in his house bank? are they deep cycle? dual purpose? , AGM? FLA ? 24's, 27's 31's? Did you need a signal splitter or were you able to run each head unit zone directly to each amp? Since you have so many channels, did you have to combine any coaxials into a 2 ohm load or were you able to keep the amps at 4 ohms throughout? Impressive. That is a massive amount of work.