Springfield will have one from the factory. The frames have molding marks in the back where a thumb safety would be, so I would bet money they will be available soon
My only problem is that when I put the flat sides facing out like you recommend it shifts around and when I go to clean it after shooting the guide rod is always cockeyed a little and I’ve noticed slide wear on one side and not the other. It seems like the flat side would be the “seated” side right?? But you say opposite?? And it moves around. It always shift to where either the flat side is now down after I shoot or it’s halfway between the rounded and flat side kind like seated on the “corner” after shooting. Something’s not working right.
Maybe some people would like to swap at will, full rod spring setup makes more sense. I wouldn’t purchase until this is available. Also don’t like side cuts being flat, may cause ware issues@@m33ch_1
I’ve heard although heavier tungsten is much softer and tungsten guide rods have been known to snap in half believe it or not. Crazy I know but I heard it’s true
From the time the pistol arrived in our posession to platform launch was very short. We only had enough time to get 20 of each color made so we could release on launch day, those sold out in mere hours. More are going to be in stock on Tuesday 8-22-23
Everything looks good about that gun except the new mag type, whoever comes out with frame modul that accepts Glock or SIG mags for these will make a fortune!
@@gdoc3 They are proprietary not even compatible with XDM line, so if they released frame modules for Glock or SIG mags of which there are tons out there they would actually have a "Glock killer" in the market.
