How to Mount Outdoor Sculptures and Pedestals by Zhki's Gallery 

Hi Amy, I would use a whole can of spray foam insulation.As was the can is opened and used it can be used again at a later time. As it hardens the outlet of can. So I would fill it up as much as you can with the whole can. I would then put a piece of duct tape over the whole country in the piece right side up again to let all the phone settle to the bottom. They make two kinds of foam insulation one is for gaps in cracks and the other is for windows it doesn't expand as much. So I would use the more expanding one, that is the one for gaps in cracks. It will take a couple days were to dry inside the statue maybe even longer since it is now a sealed environment. After it dries I would insert your Rod and see how firm it sticks into the foam. It is still seems wobbly I would remove the Rod. There would then be of course the whole were your Rod was. At that point I would add the gorilla glue which is an expanding polyurethane and will grab the Rod as it dries. I hope all that makes sense. Mike

I would use a ceramic tile bit and not a masonry bit. The ceramic tile bit is designed specifically for ceramic glazed tile. They come from sizes 1/8 of an inch to 3/8 of an inch in size and can be found in most homes centers. I do believe however freight also carries a set of them as well. These bits are shaped a little different than a masonry bit and that they have a triangular point on them that is tungsten carbide. Just go slow through ceramic. Good luck hope this helps