How To Set Clutch Clearance on Your 6000-series HRB 

Really nice of Tilton to reply to the questions here. Sheesh, nice service.

Hello I have a question when measuring air gap spacing on a t56 slave what do I do if both measurements are equal ?? as in (no air gap) adjusting slave out will make it tighter applying more pressure on throwout bearing..

I plan to use a pump and release valve to open the clutch automatically, how do you suggest I adjust the throw limit with this setup? Thank you

Are these available for Hellcat Challengers? If so what is the part number?

What keeps the threaded adjusting sleeve from vibrating out of adjustment ?

Hey if you’re using the 0.25in bar to measure the distance again at 1:45 you have to add it back to the final measurement number, or just never subtract it in the first place right?

Good info, thanks!

The bearings they use on these are absolute garbage. A large flat-faced bearing that you cannot source ANYWHERE except through Tilton, at $50 each. I wish I had never bought my Tilton 6000 series hydraulic release bearing. It's a beautiful piece of machining, but even a standard Ford Ranger oem replacement slave cylinder/throw-out bearing out-performs and outlasts this Tilton garbage.