Sir salamat sa mga idea na binibigay mo.. napaka informative at easy to understand.salamat ng marami Sir mabuhay ka oo at keep safe always,god bless po.
Yes good diagnosis we also diagnosis in automobile same like bypass the connection. I have on questions you use battery 2 12v battery why not connect 24v to exciter if put what will happen.? And to get maximum output of the genset how much voltage supply to exciter from avr ? is exciter directly connected main generator through rotating rectifier to become rotor will be electro magnet.? Avr get or use power from battery or line? Or avr use permanent magnet generate?
Magaganda po ang sharing mo about gensets sir. Tanong ko lang po regarding sa avr kung hindi nagbuild up ng voltage.pag magexcite po ba sir tatanggalin yung connection ng sensing sa avr at pati yung F1 F2?.
Yes sir tangal lahat yan sa avr kasama voltage sising e isolte mo lang tapos yung F1 F2 ay yan ang ilagay mo sa battery dapat nasa 300-500vac out normal yan
You can but that is not safe you need you voltage sensing and excitation connected to the lamp and voltage potentiometer in order to adjust the voltage sensing to check if excitation level is increasing or not
i have only two wire from excitation they don't have any marking, whether f1 or f2, x or xx, red or white. how do i understand which one is negetive or possitive that is my prblem@@benzblogsVlogs
if i accidently connect my excitation wires wrong position such as positive wire to minus port of avr and negative wire to plus port of avr does my avr became fault@@benzblogsVlogs
Sir, new subscriber mo..matanong ko lng sir, kapag nabura na yung marka sa dalawang wire ng exciter field na may + at -,, ano ba ang gagawin mo sir? Paki sagit nman po!
If you want to know try to excite if the voltage lower down meaning you put the positive wire in nigative reverse so you know now excite again and if the volatge higher meaning that is correct polarity you holding +and -
Sir, yung F1 at F2 ng AVR icoconnect direct sa 12V battery tapos start ung gen.set o start muna ung gen.set bago iconnect yung F1 at F2 sa battery?? Di po kasi nakita sa video ung complete set up. May problema kasi ako sa gen.set, same ng video nyo problema, nagoalit nako ng AVR ganun pa din, ibig sabhn nawala ung excitation voltage nya.
Pag nag excite ka sir dapat tangalaing mo volatge sensing tapos f1f2 yung ang i connect mo sa 12 volt habang omaandar ang engine dapat may makokoha kang voltage from 300-500 ac
@@benzblogsVlogs ibig sabhn sir, start ko muna ung gen.set saka ko iconnect yung f2 at f2 sa battery or iconnect ko muna bago sstart ung gen.set?? Same lang ba ng results yan?
If you want to reset thin what ever the alarm is your going to rectify first in order to reset the alarm its always vary what type of module your using