Intex Seahawk 4 Motor Mount Wheels / Transom wheels 

Thanks for watching

@@truewealth50 thanks for the suggestion, appreciate it much.

Thanks for watching

Thanks for watching

Thanks for watching

Nice to meet you too and thank for watching my friend

You welcome dear friend thanks 🙏

thanks for watching my friend

1 x 1 inch aluminum tubing, thanks for watching.

Thank you, I appreciate much.

Thanks for the advice and for watching

Thanks for visiting my friend

1x1 inches. Thanks for watching

@@cesar8359 Thanks a lot

You're right Mark dolly cart would be much stronger but I haven't made a dolly yet

​@@cesar8359Just a thought, 10" wheels would be better I think because it would raise the stern of the boat higher.

@@markweatherall7437 thanks for the tip, it's a good idea but my boat has been punctured and can't be repaired that's why I switched to kayaking.

No, I haven't experienced that issue mate

I experienced similar issue with mariner 3 and took quite a while to figure it out. Most of leaks happen along the vertical seams. you may find these leaks using soapy water. They are very very small, the diameter of each bubble may be less the 1/4 millimeter. dozens bubbles show together after 1 min with soap water at leaky point. I fixed about 100 +/- such leaks using LOCTITE Vinyl, Fabric and Plastic glue. AirStop also work, but much more expensive.

Thank you 😊

Thanks for watching. The size of the U rings were 1/4 inch by 6 inch.

Thanks for the suggestion Jack appreciate it much.

Make a Dolly instead, much better.

Thanks for watching and for subscribing, appreciate it much 🙏. The materials I used were a 1x1 aluminum tubing, 3/8 × 2 3/4 nuts and bolts, plastic wheels, 1/4 × 4 U bolts with nuts and locking pins

@@cesar8359 thank you so much. Take care ❤ bro.